Advertisement
2.
PARTS
Top View
1.
Time button
2.
Function switch
3.
PM indicator
4.
Auto Indicator
5.
Minute button
6.
Snooze button
7.
Hour button
8.
Sleep set button
9.
Alarm button
10.
Tuning control knob
11.
Band switch
12.
Volume control knob
13.
FM antenna
14.
Battery compartment
15.
Power Cable
3.
FITTING THE BACK UP BATTERY
It is advisable to fit a battery (not supplied) in the battery compartment to prevent the loss of the display time and settings
during a power failure.
To install the battery
3.1
Slide off the battery compartment cover from the underside of the unit.
3.2
Insert 1 x 9V heavy-duty alkaline battery. Insert the positive (+) round terminal of the battery into the negative connector.
Fit the round connector into the negative (-) terminal of the battery. Take care to observe the correct polarity (+/ -).
3.3
Refit the battery compartment cover.
3.4
DO NOT expose the batteries or the installed batteries to excessive heat (e.g. fire, sunshine or position close to radiators
etc.).
Note! Dispose of used batteries responsibly at local authority household waste recycling facility.
•
DO NOT dispose of batteries in a fire as the batteries may explode.
•
Only use 9V batteries in this appliance.
•
Be sure to insert correctly taking care to observe the correct polarity (+ and -).
•
Use only batteries of the same or equivalent type as recommended.
•
DO NOT
recharge non-rechargeable batteries.
•
Never try to dismantle batteries.
•
DO NOT
short-circuit the supply terminals.
•
Always remove exhausted or dead batteries from the product, do not dispose of in fire.
•
Remove batteries from the product before extended storage.
Underside
CR01
Issue No: 1 - 24/06/09
Advertisement
