Troubleshooting Guide; Start Up Conditions; Thermal Expansion; Strange Soun - Kenmore POWER MISER 153.32636 Owner's Manual

Troubleshooting Guide
Start Up Conditions
THERMAL EXPANSION
Water supply systems may, because of such events as high line
pressure, frequent cut-off_, the effects of water hammer among
others, have installed devices such as pressure reducing valves,
check valves, back flow preventers, etc.-to control these types of
_roblems. When these devices are not equipped with an internal
y-pass, and no other measures are taken, the devices cause the
water system to be dosed. As water is heated, it expands (ther-
mal expansion) and closed systems do not allow for the expan-
sion of heated water.
The water within the water heater tank expands as it is heated and
increases the pressure of the water system. If the relieving point of
the water heater's temperature-pressure relief valve is reached, the
valve will relieve the excess pressure. The temperature-pressure
relief valve is not intended for the constant relief of thermal
expansion. This is an unacceptable condition and must be cor-
rected.
It is recommended that any devices installed which could create a
closed system have a by-pass and/or the system have an expan-
sion tank to relieve the pressure built by thermal expansion.
Thermal expansion tanks are available from Sears stores and
through the Sears Service Centers. Contact the local plumbing
inspector, water supplier and/or the Sears Service Center for
assistance in controlling these situations.
Thermal Expansion Tank Specifications
Model _lhnk Capacity Dimensions in Inches Pipe Fitting
Number In Gallons Diameter Length On "Ihnk
153.331020 2 8 inches 12_ inches 74"Male
153.331050 5 11 inches 14_ inches 74"Male
Expansion Tank Sizing Chart
Expansion
_nk
Capacity
Needed
Inlet*
Water
Pressure
40psi
50psi
60psi
70psi
80psi
Water Heater Capacity (Gallons)
30 40 50 66 80
2 2 2 5 5
2 2 2 5 5
2 2 5 5 5
2 2 5 5 5
2 5 5 5 5
*Highest recorded inlet water pressure in a 24 hour period or
regulated water pressure.
NOTE: Expansion tanks are pre-charged with a 40 psi air
charge.. If the inlet, . water pressure is higJ.her than 40 psi, the
expansmn tanks a_r pressure must be adjusted to match that
pressure, but must not he higher than 80 psi.
HOT
COU_
WATER HEATER (3)
- COLD WATER PRESSURE
INLET FITTING REDUCING
VALVE WITH
BY-PASS
(0 1
EXPANSION
TANK
(z)
PRESSURE G AUGE
WATER
SHUTOFF
RECOMMENDED INSTALLATION
(VERTICAL MOUNTING)
WATER HEATER
COLD WATER
INLET FITTING
FLOOR, CEILING
JOIST, ETC.
HOT
COLD
STRAPPING
O)
EXPANSION
TANK
(3)
PRESSURE
REDUCING INLETCOLD
VALVE WITH WATER
BY-PASS SHUTOFF
(z)_
PRESSURE G AUGE
ALTERNATE RECOMMENDED
INSTALLATION
(HORIZONTAL MOUNTING)
STRANGE SOUNDS
Possible noises due to expansion and contraction of some metal
_arts during periods of heat-up and cool-down do not represent
armful or dangerous conditions.
21