Advertisement
INSTRUCTION MANUAL
BEDIENUNGSANLEITUNG
MANUEL D'INSTRUCTIONS
Í [
B/W CCD Camera
CCD-Schwarzweißkamera
Caméra CCD Noir et Blanc
C CD
u
½ ú T
About this manual
• Before installing and using the camera, please
read this manual carefully. Be sure to keep it
handy for later reference.
• This manual gives basic connections and
operating instructions for 2 PAL models
(VCB-3170P, 3100P).
À propos de ce manuel
• Avant d'installer et d'utiliser la caméra, veuillez
lire ce manuel attentivement. Gardez-le à
portée de main pour toute référence ultérieure.
• Ce manuel couvre les branchements et
instructions pour l'utilisation de base pour 2
modèles de format PAL (VCB-3170P et 3100P).
VCB-3100P
VCB-3170P
Über diese Bedienungsanleitung
• Lesen Sie bitte vor der Montage und dem
Inbetriebnehmen der Kamera zuerst diese
Bedienungsanleitung sorgfältig durch und
bewahren Sie sie zum späteren Nachschlagen
auf.
• In dieser Anleitung finden Sie die Anschlüsse
und die Grundbedienung für 2 PAL-Modelle
(VCB-3170P und 3100P)
P [
•
- Í ½ ú T \ ä =
[ t
•
[ ,
2
PAL
3100P)
Í
Í [
T
(VCB-3170P,
- Ý
Advertisement
Related Manuals for Sanyo VCb-3100P
Summary of Contents for Sanyo VCb-3100P
- Page 1 INSTRUCTION MANUAL VCB-3100P BEDIENUNGSANLEITUNG VCB-3170P MANUEL D’INSTRUCTIONS Í [ B/W CCD Camera CCD-Schwarzweißkamera Caméra CCD Noir et Blanc C CD ½ ú T About this manual Über diese Bedienungsanleitung • Before installing and using the camera, please • Lesen Sie bitte vor der Montage und dem read this manual carefully.
-
Page 2: Table Of Contents
TROUBLESHOOTING........12 • High sensitivity, minimum required illumination of 0,1 lux with F1.2 lens SPECIFICATIONS ..........13 • Horizontal resolution – Model VCB-3100P more than 400 TV lines ACCESSORIES – Model VCB-3170P more than 560 TV lines C mount adaptor (5 mm) ....1 pc. -
Page 3: Precautions
Disconnect or where it could be subject to direct the power cord immediately, and consult sunlight, as that could cause deformation, your dealer (or a Sanyo Authorized Service discoloration or other damages. Centre). Be careful when installing close to the... -
Page 4: Parts Names
PARTS NAMES Power indicator (POWER) Comes on when the power to the camera is on. Video output connector (VIDEO OUT: BNC type) Connect this connector to a device such as a VCR or monitor with a VIDEO IN connector. AC power cord External sync composite video signal input connector (VS IN: BNC type) Connect to this connector the synchronizing signal output... - Page 5 (see page 8 "SETTINGS"). To access the controls, remove the cover fixing screw, then remove the cover. Control name VCB-3170P VCB-3100P Internal/Line lock switch [VCB-3170P] (SYNC) Auto gain control switch (AGC)
-
Page 6: Mounting The Lens
PARTS NAMES Flange-back adjustment screw (FLANGE BACK ADJ.) Flange-back lock screw (FLANGE BACK LOCK) Flange-back adjustment If the pick-up surface is not correctly positioned with relation to the lens focal point, the picture will be out of focus (in particular when using auto-iris power zoom lenses, sold ADJ. - Page 7 Installation of a VIDEO type auto-iris lens (sold separately) 2 (A) A 1/2 or 2/3 inch C mount type lens with EE amplifier circuit that uses the video signal and a DC power source. Remove the lens mount cap. Attach the supplied C mount adaptor (A) to the auto-iris lens (B), then install the assembly on the camera.
-
Page 8: Connections
MOUNTING THE LENS If using Sanyo (DC type) auto-iris lens • VCL-CS8LY: Standard angle, f= 8 mm • VCL-CS4LY: Wide angle, f= 4 mm • VCL-CS2LY: Ultra-wide angle, f= 2.8 mm If using a VIDEO type auto-iris lens • Set the ALC and LEVEL controls on the lens to adjust the iris. -
Page 9: Settings
SETTINGS [VCB-3100P] [VCB-3170P] VR301 VR301 E. S. E. S. SYNC VIDEO VIDEO A. I. A. I. VR302 LENS LENS Line phase adjustment When using a camera switcher to connect 2 cameras or more to one monitor, there may be a vertical roll of the images when switched. - Page 10 (model VCB-3170P) or the EI and BLC switches (model 1/10000 sec. VCB-3100P) must be set to the OFF position. • Using the high speed electronic shutter indoors with low lighting, will give darker pictures. In such a case, add some lights to make sure the lighting is sufficient.
- Page 11 Use a manual or fixed iris lens and set the lens aperture to the shortest F stop. Set the EI/BLC switch (model VCB-3170P) to EI (electronic iris)-ON or the EI switch (model VCB-3100P)) to the ON position. The dynamic range of the electronic iris will be as indicated in table...
- Page 12 (backlight compensation)-ON position, to engage the backlight compensation function. Use an auto-iris lens. Set the EI/BLC switch (model VCB-3170P) to BLC-ON or the BLC switch (model VCB-3100P) to the ON position. If using a VIDEO type auto-iris lens (VCB-3100P) • The ALC volume on the lens should be turned all the way to Av (Average).
-
Page 13: Troubleshooting
TROUBLESHOOTING Before taking the camera for repairs, please check below to make sure that the camera is used correctly. If it still does not perform correctly, please consult your dealer or a Sanyo Authorized Service Centre. No picture on the monitor screen •... -
Page 14: Specifications
Picture elements : 795 (H) x 596 (V): VCB-3170P, 542 (H) x 584 (V): VCB-3100P Effective picture elements : 752 (H) x 582 (V): VCB-3170P, 512 (H) x 582 (V): VCB-3100P Synchronizing system : Internal sync/Line lock manually switchable/External sync... - Page 15 VIDEO OUT VS IN POWER LINE PHASE 1/4”–20 UNC Features and specifications are subject to change without prior notice or obligations. English...
- Page 16 1AC6P1P1291-- SANYO Electric Co., Ltd. L73M5, N5/XE (0796SY) Printed in Japan...