Table of Contents
Advertisement
PREPARATION
1 Make sure that the RC-2000, the speaker, and the
cables are connected as shown {page 6}.
2 Connect the transceiver to a DC power supply or
12 V vehicle battery {page 5}.
OPERATION
1 Press [
] (POWER) briefly to switch the transceiver
ON.
•
Upon power up, "KENWOOD MOBILE
CONTROLLER HELLO!!" momentarily appears,
followed by the current operating frequencies and
other indicators.
QUICK START
RC-2000
MOBILE CONTROLLER
• Assuming you want to operate the HF band on the
main transceiver and VHF band on the sub-
receiver.
2 Turn the SUB SQL (right outer ring) and MAIN and
SUB AF (both center knobs) controls to
approximately the 9 o'clock position. Turn the MAIN
SQL (left outer ring) control fully counterclockwise.
3 Press the MAIN AF (left) or SUB AF (right) control to
select the operating band.
• The "PTT" icon moves to indicate which band is
currently selected for the TX band. The frequency
information shown in a large font is selected for
the current control band.
4 Press [F1] until you select group A–1 {page 13}.
5 Press [DOWN] or [UP] to select your desired band.
6 Press [MODE] to select your desired operating mode
{page 15}.
7 Turn the Tuning control to adjust the frequency.
• The frequency shown in a large font changes.
8 Press and hold Mic [PTT], then speak in your normal
tone of voice.
9 Release Mic [PTT] to receive.
10 Repeat steps 8 and 9 to continue communication.
Note: You may have to adjust the AF and SQL controls further in step 6.
7
Hide quick links:
Advertisement
Table of Contents
