1-7. LCD PANEL, ILLUMINATION MODULE, HL5 BOARD, AND HEAT SINK REMOVAL
1
Remove Flexible Flat (LVDS) cable and connector assemblies from the LCD panel
2
Remove 3 screws and release LCD panel from Front Cabinet Assembly (KDL-40XBR9 ONLY)
Remove 5 screws and release LCD panel from Front Cabinet Assembly (KDL-46XBR9 ONLY)
Remove 6 screws and release LCD panel from Front Cabinet Assembly (KDL-52XBR9 ONLY)
3
Disconnect 1 connector from HL5 Board and release from LED Guide on Front Cabinet Assembly
4
Disconnect 1 connector from Illumination Module and remove from Front Cabinet Assembly
5
Remove 4 screws and detach 2 Heat Sinks from LCD Panel
CAUTION: The Heat Sink, Radiation Sheet, and Insulating Sheets are not included with the LCD Panel and
must be replaced when replacing the LCD panel.
Insulating Sheet (D) Detail
Double Sided Tape
KD-40XBR9 ONLY
KD-46XBR9 ONLY
KD-52XBR9 ONLY
KDL-40XBR9/46XBR9/52XBR9
For part number information, refer to the Exploded View Section of this manual.
Screw,
5
+PSW M3X8
Radiation
Sheet
Insulating Sheet (G) Detail
KD-40XBR9 ONLY
KD-46/52XBR9 ONLY
Insulating
Sheet (D)
KDL-40XBR9/46XBR9/52XBR9
Insulating Sheet (G)
1
LCD Panel
Illumination
Module
4
HL5
3
Front Cabinet Assembly
20