Installation In A Home - Kenwood KTC-H2A1 Instruction Manual

Installation in a home with the KPA-H2H kit (available separately)
Note: Do not put Here Anywhere in the docking station until you have completed the installation.
2
1. Using the provided screw, 2A. Plug the audio
assemble the docking station
cable's mini
cradle to the base. connector into the
back of the
cradle, as shown.
10
3. Plug the AC cord into the power
2B. Plug the audio
supply, then plug the power supply
cable's white
into the back of the cradle, as shown.
(L ch,) and red
Don't plug the AC cord into a wall out-
(R ch.) connectors
let until the installation is completed.
into your audio
system.
Here Anywhere Instruction Manual
2
Installation in a home (continued)
5. Due to the paths of SIRIUS satellites over the US, the best location for the antenna in your
4. Plug the antenna into the back
home depends on where you live. Use the map below as a general placement guideline—
of the cradle until it is firmly
some experimentation may be needed to obtain the best results. In major US cities, you
seated, as shown.
may also be able to receive the signal from SIRIUS ground repeaters, which may allow you
to place the antenna away from a window. In all cases, since the antenna is weather-proof
if necessary you can also locate it outside, clear of any overhead obstructions. (This is
especially important if your house has an extended roof or extended window frame struc-
tures.) See pg. 25, Antenna Signal , for more information about using the ANTENNA SIGNAL
screen to aim the antenna.
Section 1: Place the antenna at an EAST-FACING window
Section 2: Place the antenna
OUTSIDE, away from any over-
head obstructions
Section 3: Place the antenna at
a WEST-FACING window
Section 4: Place the antenna at
a NORTH- or EAST-FACING
window
Section 5: Place the antenna at
a NORTH-FACING window
Section 6: Place the antenna at
a WEST- or NORTH-FACING
window
Here Anywhere Instruction Manual
2
1 2 3
4 5 6
11