Service Instructions; Replacing Light Bulbs; Maintenance Of Motors - Kenwood HES20 Installation Instructions And Homeowner's Manual

WARNING: Disconnect power before
attempting any maintenance or cleaning
to reduce the risk of fire, electrical shock
or personal injury.

Maintenance of Motors

The motors used on the fan and the flame generator
assembly are prelubricated for extended bearing life
and require no further lubrication. However, periodic
cleaning/vacuuming of the fan/heater unit is recom-
mended.
WARNING: Make sure the power is turned
off before proceeding.
6

Service Instructions

This stove uses two clear 120 Volt, 40 Watt, E-12
socket base light bulbs (small base, chandelier candle
type). The 40 Watt bulbs are located under the log
set/ember bed. For convenience, if one of the bulbs
burns out, it may be a good idea to replace both of the
light bulbs.
1. Turn off power to the unit by unplugging the power
2. Let stove cool if it has been operating.
3. Remove the access plate on the back of the stove
CAUTION: Be careful not to touch or bend the flame
4. Examine the bulbs to determine which bulb needs
5. Unscrew defective bulb(s).
6. Install new 40 Watt light bulb(s).
7. Replace access plate. Plug power cord into wall

Replacing Light Bulbs

cord.
by removing the screws. You should have a clear
view of the light bulbs. Put your hand over the silver
flame generator to remove or replace the light
bulb(s).
generator.
to be replaced.
outlet.
WARNING: Do not exceed 40 watts per
bulb. Use of higher rated bulbs may result
in a fire, causing property damage or per-
sonal injury.
10005632