Displaying And Setting The Water Hardness - Miele G 4920 Operating Instructions Manual

Displaying and setting the water
hardness
 Switch the dishwasher off with the 
button, if it is switched on.
 Press the Start button in and whilst
holding it in switch the dishwasher
on using the  button.
Keep the Start button pressed in for
at least four seconds until the Start
indicator light comes on.
If this does not happen, start the proce‐
dure from the beginning again.
 Press the  button twice.
The  indicator will flash rapidly twice
at intervals.
Before using for the first time
The value set for the water hardness is
shown as a figure after  in the display
(see chart).
   will start flashing in the display.
This is the factory default setting of
15°d.
 Use the Start button to select the val‐
ue which equates to your water hard‐
ness level.
Each press on the button moves you
up a level. When the highest water
hardness level is reached, the setting
starts from the beginning again.
The setting is now stored in memory.
 Switch the dishwasher off with the 
button.
21