Advertisement
Options
■
KMC-9C
Desktop Microphone
■
KMC-27A
Microphone
(noise-canceling)
■
KMC-27B
Microphone
■
KMC-28A
Keypad Microphone
(noise-canceling)
Specifications
Model
GENERAL
Frequency Range
Type1:
Number of Channels (Zone)*
Conventional CH:
Trunking ID:
Channel Spacing
Wide:
Narrow:
Operating Voltage
Current Drain
Standby:
Receive:
Transmit:
Duty Cycle
Operating Temperature Range
Frequency Stability
(-22ºF ~ +140ºF)
Antenna Impedance
Dimensions (W x H x D)
Weight (net)
FCC ID
Band Spread
* During simultaneous operation of conventional and LTR
Conventional channel/trunking ID can be programmed up to 512.
®
FleetSync
is a trademark of Kenwood Corporation.
LTR
®
is a registered trademark of Transcrypt International.
Applicable MIL-STD & IP
Standard
MIL 810C
Methods/Procedures
Low Pressure
500.1/Procedure I
High Temperature
501.1/Procedure I, II
Low Temperature
502.1/Procedure I
Temperature Shock
503.1/Procedure I
Solar Radiation
505.1/Procedure I
Rain
506.1/Procedure II
Humidity
507.1/Procedure II
Salt Fog
509.1/Procedure I
Dust
510.1/Procedure I
Vibration
514.2/Procedure VIII, X
Shock
516.2/Procedure I, II, III, V
■
KCT-18
Ignition Sense Cable
■
KCT-22
Remote Control Cable
8 feet
17 feet
25 feet
TK-7150
TK-8150
136~174MHz
450~500MHz
Max.128 (1 zone x 128ch ~ 128 zones x 1ch)
Max. 250/zone (max.32 zones)
25kHz, 30kHz
25kHz
12.5kHz, 15kHz
12.5kHz
13.6V DC±15%
0.5A
0.5A
2.3A
2.3A
Less than 12A
Less than 13A
Transmit: 20%
-22ºF ~ +140ºF (-30ºC ~ +60ºC)
±0.00025%
50 Ω
7-1/12" x 2" x 7"
(180mm x 50mm x 170mm)
5.9 lbs (2.7kg)
ALH32273110
ALH32283110
38MHz
50MHz
modes.
®
MIL 810D
Methods/Procedures
500.2/Procedure I, II
501.2/Procedure I, II Cat. A1
502.2/Procedure I, II Cat. C1
503.2/Procedure I Cat. A1, C1
505.2/Procedure I
506.2/Procedure II
507.2/Procedure II
509.2/Procedure I
510.2/Procedure I
514.3/Procedure I Cat. 8
516.3/Procedure I, IV, V
■
KCT-23
DC Power Cable
Medium Power
Dash (10 feet)
Medium Power Remote
(Positive: 23 feet,
Negative: 3.3 feet)
■
KES-5
External Speaker
■
KLF-2
Line Filter
All accessories and options may not be available in all markets. Contact an authorized
Kenwood dealer for details and complete list of all accessories and options.
Model
RECEIVER
(Measurements made per EIA/TIA-603)
Sensitivity
12dB SINAD:
20dB Quieting:
Selectivity
Wide:
Narrow:
Intermodulation
Wide:
Narrow:
Spurious Response
Audio Output
External:
Internal:
TRANSMITTER
(Measurements made per EIA/TIA-603)
RF Output Power
High:
Low:
Type of Emission
Wide:
Narrow:
Spurious Response
FM Hum & Noise
Wide:
Narrow:
Microphone Impedance
Audio Distortion
Kenwood follows a policy of continuous advancement in development.
For this reason specifications may be changed without notice.
MIL 810E
MIL 810F
Methods/Procedures
Methods/Procedures
500.3/Procedure I, II
500.4/Procedure I, II
501.3/Procedure I, II Cat. A1
501.4/Procedure I, II
502.3/Procedure I, II Cat. C1
502.4/Procedure I, II
503.3/Procedure I Cat. A1, C1
503.4/Procedure I, II
505.3/Procedure I
505.4/Procedure I
506.3/Procedure II
506.4/Procedure III
507.3/Procedure II
507.4
509.3/Procedure I
509.4
510.3/Procedure I
510.4/Procedure I, III
514.4/Procedure I Cat. 8
514.5/Procedure I Cat. 20
516.4/Procedure I, IV, V
516.5/Procedure I, IV, V
■
KPS-10A
Regulated DC
Power Supply
■
KPS-15
DC Switching
Power Supply
■
KRK-9
Single Control Head
Remote Kit
TK-7150
TK-8150
0.35µV
0.45µV
84dB (±30kHz)
80dB (±25kHz)
76dB (±15kHz),
73dB (±12.5kHz)
76dB (±12.5kHz)
77dB (±30, 60kHz)
79dB (±25, 50kHz)
75dB (±15, 30kHz)
73dB (±12.5, 25kHz)
85dB
12W (@ 4 Ω 3% distortion)
13W (@ 4 Ω 5% distortion)
3.2W (@ 16 Ω 3% distortion)
3.5W (@ 16 Ω 5% distortion)
50 to 15 watts
45 to 15 watts
50 watts
45 watts
15 watts
15 watts
16K0F3E, 20K0F1D
11K0F3E, 11K2F1D
75dB
48dB
42dB
600 Ω
Less than 1% at 1000Hz
footnotes from Front:
1
KRK-9, KCT-22M/M2/M3, KCT-23M/M3
remote control options required.
2
6-Pin Accessory Connector for external
speaker, PA Output & ignition sense input.
3
KCT-18 ignition sense cable option required;
plugs into mobile 6-pin jack ignition sense input.
Built-in PA/HA outputs (no option board
4
required); Horn Alert operates for 2-Tone or
DTMF selective call decode only.
5
Short Text Messages are radio stored & LCD
displayed; Long Text Messages require a
KDS-100 and KCT-40.
6
FleetSync
®
GPS features require an internal
GPS board or externally wired GPS receiver
with NMEA TTL level serial data output to
the internal COM 1 or 2 set to "GPS".
JQA-QMA1205
ADS#26608 Printed in USA
Advertisement
