Kenwood Axcess Axcess Remote Portal User Manual page 19

Once Axcess enters the manual configuration mode, the IP address appears:
1. Use the left/right arrow buttons to select the number you want to enter
(the selected number will blink).
2. Use the up/down arrow buttons to change the number.
3. Repeat steps 1–2 until the correct IP address shows on the display.
4. Once you have entered the correct IP address, press the
Axcess will show the gateway address:
5. Use the left/right and up/down arrow buttons as before to enter the cor-
rect gateway address.
6. Press the
SELECT
up/down arrow buttons as before to enter the correct network mask.
7. Press the
SELECT
up/down arrow buttons as before to enter the correct DNS address.
8. Press the
SELECT
9. If you entered all the network information correctly, press the up or down
buttons until the bottom line reads "Yes" and press the
OR If you made a mistake entering any of the network information, press
the up or down buttons until the bottom line reads "No", and press the
button. Axcess returns to the network configuration screens.
SELECT
Repeat steps 1–9.
Complete Guide to Your Axcess Remote Portal
information from your Internet Service Provider (ISP). If your
network uses a static IP address, you can also get the
information directly from your Entré. For more information,
see "Network Configuration" on page 7 of How to Connect
and Set Up Your Axcess Remote Portal.
button. The network mask appears. Use the left/right and
button. The DNS address appears. Use the left/right and
button. "Done?" appears in the top line.
How Do I Turn On Axcess?
SELECT
button.
SELECT
button.
13