Advertisement
Check the head for any damage or deformation before use.
(Cause of skin damage)
Never use this product together with other beauty treatment devices at the
same time. (Cause of a failure or trouble)
Never use this product if there is some injury or wound to your skin.
(Cause of skin trouble or pain)
Do not drop this product, or give it a strong impact.
Prohibited
(Cause of injury or a failure)
Do not wipe with benzene, thinner or alcohol, and do not spray insecticide.
(Cause of cracking, an electric shock, or ignition)
Use only the attached charger. And, do not charge any other product
with the attached charger. (Possibility of an electric shock or ignition)
Remove accessories such as earrings and necklaces, and contact lenses for
use. (Cause of an accident or trouble)
If there is any severe skin disorder or irregularity on your skin surface, or due
Make sure
to downy hair, you may feel strong irritation in rare instances. In this case,
avoid using this product on that region. (Cause of an accident or trouble)
Do not keep the cotton puff on one part of your skin but always keep it in
motion. (Cause of skin trouble or poor physical condition)
Pull out the power plug and device plug without holding the cord.
(Cause of disconnection, an electric shock, short circuit, or ignition)
Make sure to pull out the power plug from the outlet unless used.
(Cause of an electric shock or fire by deterioration)
Unplug
Names of parts and their functions (Fig. 1)
Head (titanium material)
Set a cotton puff and apply it to the skin.
This section vibrates during use.
Mode indicator lamp (orange)
When the power switch is turned "ON,"
"CLEANSING LAMP" flashes.
This lamp lights during use.
"MODE" selector button
Every time this button is pressed,
the mode is switched.
Side plate
Power switch ("
")
When this switch is pressed, it turns
"ON", and when this switch is pressed
again, it turns "OFF". Equipped with an
auto-off function, it will automatically turn
"OFF" if the device is not used for about
30 seconds in an "ON" state.
Body
Body socket
"LEVEL" indicator lamps
"HIGH" (red) : "LOW" (green)
When the power switch is turned "ON,"
"LOW" or "HIGH" lights.
High/low selector button
Every time this button is pressed, the
potential power level is switched between
"HIGH" and "LOW." The vibration power
does not change.
Side plate
Touch this part and apply the head to
the skin, and the device will start to
operate.
"CHARGE" lamp
The lamp lights in red during charge,
and changes to green after completion
of charge.
Buzzer (selecting sound/warning
sound/ending sound)
Every time the switch/button is pressed,
a selecting sound can be heard.
If a warning sound can be heard during
use, it is a signal to indicate recharging.
When each mode exits, an ending
sound can be heard.
About the skin sensing function
The electric circuit operates with the skin in contact with the side plate and head.
It will not operate unless the side plate is touched and the head is applied to the skin.
About the memory function
This device is equipped with a memory function for storing the potential power level
("HIGH" or "LOW") in memory.
In each mode (step 1 to 4), the power level ("HIGH" or "LOW") is stored in the memory
before an automatic stop or turning off the power switch.
The potential power level can be switched between "HIGH" and "LOW" by pressing
the "LEVEL" selector button during use.
Preparation before use
How to charge
Since this product is not fully charged, charge before the first use.
Make sure to use 100-240V AC and use the attached charger.
Do not insert or remove the power plug in/from an electric outlet
with wet hands. (Cause of an electric shock or short circuit)
Never use this product in places splashed with water or in damp places,
such as in a bathroom. (Cause of an electric shock or short circuit)
1. Turn off the power, and connect the charger to the main body and outlet. (Fig. 2)
The charge lamp: lights in red during charge, and
lights in green after completion of charge.
2. After the standard charging time (5 hours) has elapsed, pull out the charger from
the electric outlet and the main body. (Fig. 3)
During charge, the main body and the charger may become slightly hot, but
not an abnormality.
The standard charging time is 5 hours.
On a single charge, this device can be used approximately 10 times [when used at
the "HIGH" level in basic mode (three steps) in combination with "REFRESH"].
* Depending on the operating conditions, such as the ambient temperature,
the number of operating times may decrease.
Batteries (built-in)
Nickel-hydrogen batteries
Charger Model: KH-182B
Power plug
Insert in an outlet to the roots.
Device plug
Cord
Accessories
Rings (two)
Rings for fixing a cotton puff.
Stand
Advertisement
