Display Of Operational Status (Cpoint) During Setup; Display Examples - Pioneer DEH-1100 Service Manual

(4) Display of Operational Status (CPOINT) during Setup

Status No. Contents
01 Carriage move to home position started.
02 Carriage is moving toward inner diameter.
03 Carriage is moving toward outer diameter.
05 Carriage outer diameter feed (1 second) in progress.
11 Setup started.
12 Spindle rotation and focus search started.
13 Waiting for focus close (XSI=Low).
14 Waiting for focus close (FOK=High). (After AGC)
15 Waiting for focus close (FOK=High). (Before AGC)
16 Rough AGC in progress.
17 Setup (1/2) before T balance adjustment is started.
18 Setup (2/2) before T balance adjustment is started.
24 T balance adjustment (1/2).
25 T balance adjustment (2/2).
26 Standing by after spindle rough servo is over.
27 Setup before RF AGC (first) is started.
28 RF AGC (first) in progress.
29 Setup before RF AGC (second) is started.
30 RF AGC (second) in progress.
31 Tracking close in progress.
32 Standing by after tracking is closed.
33 Focus AGC started.
34 Focus AGC in progress. Tracking AGC started.
35 Tracking AGC in progress.
Spindle processes applicable servo.
36 Check of MIRR and LOCK pin. RF AGC in progress.
CRG close in progress. Check of sub-code.

(5) Display Examples

1) During Setup (When status no. = 11)
TRK No.
11
2) During Operation (TOC read, TRK search, Play, FF and REV)
The same as in the normal mode.
3) When a Protection Error Occurred
Switch to the following displays (A) and (B) using the [BAND] switch:
(A) Error occurrence timing display in absolute time.
An example: Error occurred in 12th tune at 34'56" in absolute time.
TRK No.
12
(B) Error No. display
An example: Error #40 (Off focus is detected)
ERROR-40
MIN. SEC.
11' 11"
MIN. SEC.
34' 56"
Protective action
None
Specified 10 seconds has been passed or failure
on home switch.
Specified 10 seconds has been passed or failure
on home switch.
None
None
None
Specified focus search time has been passed.
Specified focus search time has been passed.
Specified focus search time has been passed.
Off focus.
Off focus.
Off focus.
Off focus.
Off focus.
Off focus.
Off focus.
Off focus.
Off focus.
Off focus.
Off focus.
Off focus.
Off focus.
Off focus.
Off focus.
Off focus. Spindle not locked.
Sub-code unreadable.
DEH-1100,11
47