Specifying The Menu Display Time; Showing/Hiding Lamp Replacement Warnings - Canon WUX450 User Manual

Installation-Related Menu Settings
Specifying the Menu
Display Time
> [Install settings] > [On screen] >
[Menu display time]
HDMI Component
Digital PC Analog PC
The setting for the menu display
time can be extended from the
normal 10 or 30 seconds to 3
minutes.
Normal The menu is displayed for 10
or 30 seconds.
Extended The menu is displayed for 3
minutes.
Press the OK button to accept your
setting and then press the MENU
button or EXIT button.
• [Normal] is the factory default.
• The following display and operation are also
changed.
Item
The display time of the
following screens
- MENU screen
- Input (P54)
- Keystone adjustment
(P68)
- Keystone reset (P70)
- D.image shift
adjustment (P63, P64)
- D.image shift reset
(P65)
- Aspect (P67)
- Image Mode (P71)
- Volume adjustment
(P77)
- Gamma correction
(P100)
LAN
USB
[Normal] [Extended]
30 3
seconds minutes
10 3
seconds minutes
156
Showing/Hiding Lamp
Replacement
Warnings
> [Install settings] > [On screen] >
[Lamp warning display]
HDMI Component
Digital PC Analog PC
A message that advises you to
change the lamp can be set to
display when the lamp has been
used for the specified period of time.
On The prepare lamp message and the
lamp warning are displayed.
Off The prepare lamp message and the
lamp warning are not displayed.
When it is time to replace the lamp,
the LAMP indicator on the projector
will flash, and lamp replacement
(P202) is recommended at this time.
Press the OK button to accept your
setting and then press the MENU
button or EXIT button.
• The factory default is [On].
LAN
USB