For Wired Network Interface Users; (For Mac Os ® X 10.2.4 Or Greater) - Brother MFC-845CW Quick Setup Manual

Installing the Driver & Software

For Wired Network Interface Users

(For Mac OS
Important
Make sure that you have finished the
instructions from Step 1 Setting Up the
Machine on page 4 through 15.
1
Using both hands, use the plastic tabs on both
sides of the machine to lift the scanner cover
until it locks securely into the open position.
2
Connect the network cable to the LAN socket
marked with a
LAN socket inside the machine on the left as
shown below.
3
Carefully guide the network cable into the
trench as shown below, following the trench
around and toward the back of the machine.
Then, connect the cable to your network.
®
X 10.2.4 or greater)
symbol. You will find the
Improper Setup
Make sure that the cable does not restrict the
cover from closing, or an error may occur.
Note
If both USB and LAN cables are being used, guide
both cables through the trench with one on top of
the other.
4
Lift the scanner cover to release the lock (
Gently push the scanner cover support
down ( ) and close the scanner cover ( ).
Note
Make sure that the machine is turned on by
connecting the power cord.
Improper Setup
If you have previously set up your machine for
a wireless network and then want to set it up
on a wired network, you should check that the
machine's Network I/F is Wired LAN. The
wireless network interface will be inactive with
this setting.
On your machine, press Menu.
Press a or b to choose LAN and press OK.
Press a or b to choose Network I/F and
press OK.
Press a or b to choose Wired LAN and
press OK.
®
Macintosh
).
37