Canon image Prograf iPF780 Series Setup Manual page 2

Preparations
1
Install the printer. You can use the
following two methods for installing the
printer.
• Install with a stand
Assemble the stand and install the
printer referring to the Printer Stand
Setup Guide included with the stand.
After installation, proceed to step 4.
• Install without a stand on a table
Proceed to step 2.
3
Three people should hold the printer's carrying handles and place the printer on a table or
other fl at location.
• The iPF780 Series/iPF785 Series weighs
approximately 56 kg and the iPF680
Caution
Series/iPF685 Series approximately 46 kg
by themselves. Moving the printer requires
at least three people. Be careful to avoid
back strain and other injuries.
5
Move the printer to the location where you
will use it.
• When moving the stand, lift the support rod
to the position (a) before closing the output
Caution
stacker and unlocking the 4 casters. Failure
to do so may lead to scratched fl ooring,
damage to the basket cloth, and injury.
O F F
Prepare the printer for use by installing the printer and connecting the power cord.
• Stands may be standard or optional
depending upon your model and location.
MEMO
iPF780 Series/iPF785 Series: Standard
iPF680 Series/iPF685 Series: Optional
(equipped as standard in some locations)
• When moving the printer, fi rmly grasp the
carrying handles. Holding the printer at
other positions is dangerous, and may
cause injury and damage if the printer is
dropped.
• After you have moved the stand, be sure to
lock the 4 casters.
a
O N
2
2
Remove the packing materials from the
top of the printer.
4
Remove the orange tape used to secure
the roll holder to the printer.
6
Plug the power cord into the power supply
connector on the right of the printer and
plug the other end into the outlet.