Adjusting The Depth Of Cut; Attaching The Roller Bearing Guide; Attaching The Dust Extraction Adaptor - DeWalt DWE6000 Instruction Manual

CAUTION: To avoid personal injury and/or damage to finished
work, always allow the power unit to come to a COMPLETE STOP
before putting the tool down.
To turn unit on, pull the on/off switch (C) up. To turn the unit off, depress
the switch back down into the motor housing. Refer to Figure 6.
FIG. 6
Adjusting the Depth of Cut (Fig. 7)
1. Select and install the desired bit. Refer to Bit Installation and
Removal.
2. Assemble base to motor, ensuring base is attached to the depth
adjustment ring. Place laminate trimmer on the work piece.
3. Open the locking lever (G) and turn the depth adjustment ring (B)
until the bit just touches the work piece. Turning the ring clockwise
raises the cutting head while turning it counterclockwise lowers
the cutting head.
4. Turn the micro adjustment scale (F) clockwise until the 0 on the
scale lines up with the pointer on the quick release tab (A).
5. Turn the depth adjustment ring until the pointer lines up with
desired depth of cut marking on the micro adjustment scale.
NOTE: Each mark on the adjustable scale represents a depth
change of 1/64" or .015" (0.4 mm) and one full (360º) turn of the
ring changes the depth 0.5" (12.7 mm).
6. Close the locking lever (G) to lock the base.
C
FIG. 7
A

Attaching the Roller Bearing Guide

(Fig. 2)
A roller bearing guide guide (U) is included with your laminate trimmer
for use with non-piloted bits on curved or straight applications.
1. Remove the screw (Q) in the back of the base (H).
2. Slide roller bearing guide into guide slot (P) on back of subbase (I).
Tighten hardware.
NOTE: To remove the roller bearing guide, reverse the above
procedure. After removing roller bearing guide, always replace the
screw (Q) into the storage hole on the back of the base to prevent it
from being lost.

Attaching the Dust Extraction Adaptor

(Fig. 8)
The dust extraction adaptor (R) can be attached to the front of the
sub base underneath the locking lever as shown in figure 8. Hand
tighten both finger screws (T) and attach a vacumm hose to the dust
exhaust port (S).
34
B
F
G