Installing Door Seals - Bosch WFMC64 Repair Manual

10
WFMC Service Tips
WFMC Service Tips
Certain repairs can involve removing or disconnecting the door seal (gasket) for access. To insure proper
washer operation and prevent leaking, door seals must be reinstalled correctly.
Center notch in bottom of
seal (for spring) under
bottom of door
Dispenser
Inner
hose
spring
702_58300000133618_ara_en_a
Make sure seal is
properly seated on
front shield flange
To install door seals:
1)
Align door seal so notch (for spring) at front is centered
under bottom of door.
2)
Carefully push rear of seal over front of tub so seal
properly seats onto tub.
3)
Stretch rear spring clamp over seal and insert into
notch at rear of seal.
4)
Using small hose clamp, attach dispenser hose to seal.
5)
Work front seal lip over front shield flange (so lip
"snaps" in). Tug around entire seal to check if seated.
6)
Align clamp spring at door bottom, then insert front
spring clamp into notch of entire left half of door seal
(180º from top to bottom).
7)
While pulling right side of spring using needlenosed
pliers, pull clamp into right side seal notch, then
carefully release spring.
shield so clamp won't pull seal off.
–

Installing Door Seals

– Installing Door Seals
Place spring clamp
over left half of
seal in notch
Keep clamp
spring over notch
at seal bottom
Hold clamp next to front
Make sure clamp doesn't
pull seal off front shield
Carefully pull spring to
right & put clamp into
right side seal notch
Hold clamp
next to
front shield
NOTE: Check to make sure seal is
seated after installation so
leaking will occur.
TIP: Left-handed servicers -- start
the front spring clamp on the right
side and pull the spring to the left.
Rev 0 (1/17/08)
no