Completing The Fru Replacement - Lenovo ThinkCentre 7515 Maintenance Manual

Completing the FRU replacement

After replacing the FRUs, you need to reinstall any removed parts, reconnect and
route any internal cables, close the computer cover, and reconnect any external
cables, including telephone lines and power cords. Depending on the FRUs
replaced, you might need to confirm the updated information in the Setup Utility
program, see Chapter 6, "Using the Setup Utility," on page 49.
Note: When the power cord is first plugged in, the computer might appear to turn
To close the computer cover and reconnect external cables to your computer:
1. Ensure that all components have been reassembled correctly and that no tools
2. Ensure that the internal cables are routed correctly before lowering the drive
Figure 67. Cable routing
3. Lower the drive bay assembly and place the drive locks to the locked position.
4. If you removed the front bezel, reinstall it by aligning the three tabs on the
5. Close the computer cover.
6. If a computer cover lock is installed, lock the computer cover.
on for a few seconds and then turn off. This is a normal sequence to enable
the computer to initialize.
or loose screws are left inside your computer. See "Locating components" on
page 128 for the location of the various components.
bay assembly.
Important
Correctly route all power supply cables to avoid interference with the
drive bay assembly. Keep cables clear of the hinges and sides of the
computer chassis.
Otherwise, you cannot close the computer cover.
front bezel with the corresponding holes on the chassis and pivoting the front
bezel inward until it snaps into position.
Chapter 9. Replacing FRUs - 607 computers
155