Adjusting 90/45 Bevel Stops - Black & Decker BDMS100 Instruction Manual

ADJUSTING 90° AND 45° BEVEL STOPS
DISCONNECT MACHINE FROM POWER SOURCE!
1. Loosen the bevel lock handle (A) Fig. 18 and move the cutting arm (B) Fig. 18 all the way to the right. Tighten the bevel lock
handle.
2. Place one end of a square (A) Fig. 24 on the table and the other end against the blade. Check to see if the blade is 90° to the
table (Fig. 24).
3. To adjust, loosen the locknut (B) Fig. 25, and turn the screw (C) until the head of the screw (C) contacts the casting (D) when
blade is 90° degrees to the table. Tighten the locknut (B).
Fig. 24
4. Loosen the bevel lock handle. Move the cutting arm all the
way to the left bevel position and tighten the bevel lock
handle.
5. Use a combination square (A) Fig. 26 to see if the blade is
at 45° to the table.
6. To adjust, loosen the locknut (E) Fig. 27, and turn the screw (F) until it contacts the casting (G). Tighten the locknut (E).
7. Check to see that the bevel pointer (P) Fig. 28 is pointing to the 45° mark on the bevel scale (S) Fig. 26. To adjust the bevel
pointer (P) Fig. 28, loosen the screw (H) and adjust pointer (P). Tighten the screw (H) securely.
8. These positive stops enable you to rapidly position the blade at the 90° and 45° bevel angle to the table.
F
E
Fig. 27
A
Fig. 25
Fig. 26
G
Fig. 28
15
C
A
P
D
B
S
H