Advertisement
Quick Links
DISHWASHER-SINK
I
COMBINATION
KDC-40 & KDS-40
INSTALLATION
INSTRUCTIONS
MR. INSTALLER:
FINAL
CHECK LIST
PLACEMENT
OF DISHWASHER
- SINK COMBINATION
m
1. Properly
positioned-level,
aligned and square with cabinet opening.
CT; 2. Anchored
securely, either to cabinet or floor.
m
3. Installation
debris removed from under dishwasher.
ELECTRICAL
CONNECTION
n
1. Separate 115 volt, 60 hertz,
1 phase branch circuit
with a 15 ampere minimum
protected
by a
maximum
of 15 ampere fuse size.
c7
2. Dishwasher
properly
grounded.
n
3. All connections
in conformance
with
local electrical
code.
PLUMBING
c7
1. Water supply at dishwasher:
20 to 120 P.S.I. pressure, temperature
of 120" F. or
higher and l/2"
O.D. (min.) copper tube.
cl
2. Drain
lines at least 5/8"
O.D. copper tubing
or equivalent
without
drain air gap
and with
no tight
bends (kinks)
or other
restrictions
to prevent
complete
draining.
'J
3. Drain
lines at least g/16"
I.D. copper tubing
or equivalent
with
drain air gap
and with
no tight
bends (kinks)
or other restrictions
to prevent
complete
draining.
rI1
4. Compliance
with
all aspects of local plumbing
code.
m
5. Make sure drain hose does not touch
any electrical
components
or terminals.
OPERATIONAL
C?
1. All internal
packing material,
labels, and foam door pads removed.
Place detergent
in both compartments
of detergent
dispenser, close covers and
operate dishwasher
through
complete
LOW ENERGY
cycle.
Check:
Proper
Fill-Water
level approximately
l-1/2"
below
centerline
of 4 Way Hydro
Sweep hub. Complete
Drain.
Detergent
Dispenser-must
operate automatically
and completely
dispense
detergent.
Dishracks,
for freedom
of movement
and adjustment.
THANK
YOU
MR.
INSTALLER:
1. Complete
Installation
Check List.
2. Leave all literature
(Incl.
Check List) for customer.
3. Notify
dealer that electrical
work and plumbing
are completed.
FOR DETAILED INSTRUCTIONS,
FOLLOW METHODS DESCRIBED
IN THIS FOLDER
Advertisement
