Kenwood DNX4150BT Quick Start Manual
Hide thumbs Also See for DNX4150BT:

Advertisement

You can update the system by connecting a USB device containing an
update file.
For updating the system, visit <http://www.kenwood.com/cs/ce/>.
© 2014 JVC KENWOOD Corporation
DNX4150BT
DNX4150BTM
DNX4150DAB
GPS NAVIGATION SYSTEM

Quick Start Guide

B5K-0083-00 (MN/M2N/XN)

Advertisement

Table of Contents
loading

Summary of Contents for Kenwood DNX4150BT

  • Page 1: Quick Start Guide

    DNX4150BT DNX4150BTM DNX4150DAB GPS NAVIGATION SYSTEM Quick Start Guide You can update the system by connecting a USB device containing an update file. For updating the system, visit <http://www.kenwood.com/cs/ce/>. © 2014 JVC KENWOOD Corporation B5K-0083-00 (MN/M2N/XN)
  • Page 2: Table Of Contents

    For functions not described in this Guide, refer to the Precautions ..............3 Instruction Manual on the following website: Safety Precautions and Important http://manual.kenwood.com/edition/im386/ Information .............. 5 To refer to Instruction manual, a PC loaded with First Step ............... 6 Microsoft®...
  • Page 3: Precautions

    • When you purchase optional accessories, check play. In such a situation, remove the disc and wait with your Kenwood dealer to make sure that they for the condensation to evaporate. If the unit still work with your model and in your area.
  • Page 4: Cleaning The Unit

    Ñ Acquiring GPS signal Ñ How to reset your unit The first time you turn on this unit, you must wait If the unit or the connected unit fails to operate while the system acquires satellite signals for the properly, reset the unit. first time.
  • Page 5: Safety Precautions And Important Information

    Neither other factors that may affect safety or timing while Kenwood nor Garmin shall be liable for problems driving. or accidents resulting from failure to observe the Use the navigation system only as a navigational aid.
  • Page 6: First Step

    Camera First Step Set the parameters for the camera. (Instruction Manual P.82) Various setup screens appear automatically before After setting, touch [6]. using. DEMO Ñ Initial setup Set the demonstration mode. Default is “ON”. When you first turn on the unit, the screen of the Touch [Finish].
  • Page 7 Ñ iPod/iPhone connection setup Ñ Application link setup When you first select iPod as a source, the setting When you first select Apps as a source, the setting screen of the iPod/iPhone connection will appear. screen for the connection with the device installed the apps will appear.
  • Page 8: Functions Of The Buttons On The Front Panel

    Functions of the Buttons on the Front Panel Name/Motion Name/Motion 1 Disc insert slot 6 TEL • A slot to insert a disc media. • Displays the Hands Free screen (Instruction Manual P.67). • Pressing for 1 second displays the Voice •...
  • Page 9: Insert A Sd Card

    How to insert a microSD Card Common Operations 1) Hold the microSD card with the label side Ñ Popup menu facing right and the notched section down, and insert it into the slot until it clicks. Press the Volume knob. Ñ...
  • Page 10 Ñ General etc. There are some functions which can be operated Touch keys with various functions are displayed from most screens. here. Displayed keys differ depending on the current audio source, status, etc. For examples, see List screen (P.15) in the Instruction Manual.
  • Page 11: How To Use The Navigation System

    Garmin and JVC KENWOOD will not be responsible for any traffic fines or citations that you may receive for failing to follow all applicable traffic laws and signs.
  • Page 12: How To Play Music

    NOTE You can purchase updated map data from • Touch and drag the map to view a different area of Garmin or ask your Kenwood dealer or the map. Kenwood service center for details. • A speed limit icon could appear as you travel on 1) Go to www.garmin.com/kenwood.
  • Page 13 USB device 1) Connect the USB device with the USB cable. Plays all contents in random order. Searches previous/next folder. (disc media and USB device only) Stops playing. (disc media only) ⿠ To disconnect the USB device: Disconnects the device. (USB device and iPod 1) Touch on the left side of the screen to display only) the function panel.
  • Page 14: How To Play Movie/Picture

    How to Play Movie/Picture How to Listen to the DAB/ Radio You can play DVD video, Video CD (VCD), movie files Press the <HOME> button. from disc media, iPod and picture files from USB storage device. HOME screen appears. ✎ NOTE Touch [DAB] (DNX4150DAB only) or •...
  • Page 15: How To Make A Phone Call

    Connect your cell-phone to the unit. How to Make a Phone Call 1) Touch the device name you want to connect You can use your Bluetooth cell-phone when paired in the Bluetooth SETUP screen. to this unit. 2) Touch [ON] of [TEL(HFP)] in the BT Connection Settings screen.
  • Page 16: Installation

    Call using the preset number Installation 1) Touch [Preset #] to start calling the corresponding phone number. Ñ Before Installation 2) Touch [ Before installation of this unit, please note the Call by voice following precautions. You can make a voice call using the voice #WARNINGS recognition function of the cell-phone.
  • Page 17 Ñ Supplied accessories • Insulate unconnected wires with vinyl tape or other similar material. To prevent a short circuit, do not First of all, make sure that all accessories are remove the caps on the ends of the unconnected supplied with the unit. wires or the terminals.
  • Page 18 Ñ Unit Ñ Trim plate 1) To prevent a short circuit, remove the key from 1) Attach accessory 6 to the unit. the ignition and disconnect the ¤ terminal of the battery. 2) Make the proper input and output wire connections for each unit.
  • Page 19 Ñ GPS antenna Ñ Microphone unit GPS antenna is installed inside of the car. It should 1) Check the installation position of the be installed as horizontally as possible to allow easy microphone (accessory 9). reception of the GPS satellite signals. 2) Clean the installation surface.
  • Page 20: Installation Overview

    ⿠Installation overview Ñ Installation the Digital Radio antenna (DNX4150DAB) The antenna should be installed on the passenger side for safety. #CAUTION • This film antenna is exclusively for use inside the vehicle. • Do not install at the following locations: –...
  • Page 21 ⿠Determining the antenna installation When installing the antenna on the left side location Ceramic line (black part) 1) Remove the front pillar cover of your car. 150 mm Front pillar cover 30 mm Earth sheet * 2) Clean the windscreen with the supplied cleaner (accessory 0).
  • Page 22 When installing the antenna on the left 4) Rub the film antenna (accessory -) gently in side the direction of the arrow shown below to firmly stick it to the windscreen. Earth sheet 7) Remove the film covering the earth sheet and attach the earth sheet to the metal part of the vehicle.
  • Page 23 English ñ...
  • Page 24: System Connection

    Rear Audio Preout Front Audio Preout Subwoofer Preout When connecting to an external amplifier, Connect to vehicle’s steering remote connect its ground wire to the car's chassis harness. Contact your Kenwood dealer to avoid damaging the unit. for details. ñ English...
  • Page 25 Ñ Connecting wires to terminals Fuse (10A) Ignition key switch Accessory 1 Red (Ignition wire) White/Black Yellow (Battery wire) To front left speaker Car fuse White Car fuse Black (Ground wire) ¤ (Main fuse) (To car chassis) Gray/Black To front right speaker Gray Battery...
  • Page 26 Ñ 3 way speaker system setup (DNX4150BT Region code 3 area only) ✎ NOTE • For how to connect speaker wires to terminals other than speaker terminals and Preout terminals, see “System connection” (P.24) and “Connecting wires to terminals” (P.25).
  • Page 27 ⿠Switching between speaker systems 5) Touch [Yes]. The 2 way speaker system is switched to the 3 Switch to the 3 way speaker system following the way speaker system. procedure below. ✎ NOTE ✎ NOTE • When the 3-way speaker system is selected, •...
  • Page 28 Ñ Optional accessory connection USB maximum power supply current : DC 5 V = 1 A Sold separately Optional accessory KCA-MH100 (1.8 m) Android smartphone KCA-HD100 (1.8 m) Video Output (1.8m) USB terminal (0.8 m) iPod/iPhone iPod Lightning Digital AV Adapter USB device KCA-iP102 (0.8m)
  • Page 29: About This Unit

    See DivX(R) VOD (P.45). the Bluetooth SIG, Inc. and any use of such marks by • DivX Certified® to play DivX® video, including JVC KENWOOD Corporation is under license. Other premium content. trademarks and trade names are those of their •...
  • Page 30 – Bluetooth profile: AVRCP • libFLAC Copyright (C) 2000,2001,2002,2003,2004,2005,2006,2 Ñ iPod/iPhone connection 007,2008,2009 Josh Coalson To connect the iPod/iPhone with this unit, the Redistribution and use in source and binary forms, cable, adapter (both sold separately), and the with or without modification, are permitted profile which your iPod/iPhone supports are provided that the following conditions are met: necessary as follows:...
  • Page 31 Android™ • iPod touch (1st generation) • iPod classic • Visit Google play and search for “AUPEO!” to install. NOTE • iPod with video • Ensure you are logged in to your smartphone • iPod nano (7th generation) application. If you do not have an AUPEO! account, •...
  • Page 32: Laser Product

    Amsterdamseweg 37, 1422 AC UITHOORN, The Netherlands English Hereby, JVC KENWOOD declares that this unit DNX4150BT, DNX4150BTM, DNX4150DAB is in compliance with the essential requirements and other relevant provisions of Directive 1999/5/EC. Sembollü (üzerinde çarpı işareti olan çöp kutusu) Türkçe...

This manual is also suitable for:

Dnx4150btmDnx4150dab

Table of Contents