HP 4110 Quick Start Manual page 8

E
N
HP 4110 Quick Start Guide
G
L
I
Connect the Ethernet Cable
S
H
1.
2.
Attach the Phone to the Wall
1.
2.
8
Connect the Ethernet cable to the NET port (left-most port).
Note: The phone is a PoE phone. If you are not using PoE,
also connect an HP 5V power supply. Caution: A 48V supply, as
used by other IP phone vendors, will permanently disable this phone.
Use only a Hewlett-Packard (HP) 5V external power supply (J9767A)
NET PC
Attach the Ethernet cable to the wall jack.
Attach the phone to the wall by placing the larger portion of
the mounting holes over the screws on the wall.
Once in place, pull the phone down so that the narrow area
of the mounting holes are resting against the screws.
If no PoE available
5V DC
ENGLISH
Mounting
Holes
.
.