Display Surface - Mitsubishi Electric E1022 Installation Manual

Chemical Resistance
Ammonia <40%
Caustic soda <40%
Hydrogen peroxide <25%
Alkalicarbonate
Bichromate
Diesel oil
Acetonitrile
Sodium bisulphate
Autotex withstands DIN 42 115 Part 2 exposure of up to 1 hour duration to glacial
acetic acid without visible change.
Autotex is not resistant to high pressure steam at over 100 °C or the following
chemicals:
Concentrated mineral acids
Concentrated caustic solution
Autotex withstands 24 hours exposure to the following reagents at 50 °C without
visible staining:
Top Job
Jet Dry
Gumption
Fantastic
Formula 409
Very slight discoloration was noted under critical viewing conditions with the
following materials:
Tomato juice
Outdoor Use
In common with all polyester based films Autotex F157 is not suitable for use in
conditions of long term exposure to direct sunlight.

4.2.2 Display Surface

The display surface on the operator terminal withstands exposure of more than 24
hours duration to the following chemicals without visible change:
Acetic acid <5%
Glacial acetic acid
(specific gravity 1.05)
Ethyl acetate
Acetone
Aqueous ammonia
(specific gravity 0.9)
Aqueous ammonia <10%
Benzene
14
Linseed oil
Paraffin oil
Blown castor oil
Silicone oil
Turpentine substitute
Univeral brake fluid
Decon
Aviation fuel
Benzyl alcohol
Mehylene chloride
Grape Juice Ariel
Milk Persil
Coffee Wisk
- Lenor
- Downey
Tomato ketchup Lemon juice
Dichloromethane
Di-ethylether
Di-isobutylene
Di-methyl hormamide
Ethyl alcohol <95%
2-ethyl hexoic acid
Hydrochloric acid <35%
Dioctyl Phthalate
Sodium carbonate
Petrol
Teepol
Water
Sea water
-
-
Ajax
Vim
Domestos
Vortex
Windex
Mustard
Nitric acid
(specific gravity 1.42)
Nitric acid <40%
Oleic acid
Olive oil
Pure water
Seawater
Sodium carbonate <20%
Mitsubishi Electric, MA00854