Using The Voice Announcement - Motorola ASTRO APX O2 Control Head Mobile Radio User Manual



Using the Voice Announcement

This feature enables the radio to audibly indicate the current
feature mode, Zone or Channel the user has just assigned. This
audio indicator can be customized per customer requirements.
This is typically useful when the user is in a difficult condition to
read the content shown on the display.
Each voice announcement is within a limit of three seconds
maximum. The sum total duration for all voice announcements
in a radio shall be no more than 1000 seconds.
Note: This feature must be preprogrammed by a qualified
radio technician.
The features which Voice Announcement supports are:
•
Zone
•
Scan
•
Talkaround/Direct
•
Emergency On
•
Secure/Clear
Note: Voice announcements support certain number of
zone-channel, but not all.
Seek advice from your dealer or qualified technician for
the best selections for this feature.
108
English
•
Channel
•
Monitor (Conventional)
•
Tx Inhibit
•
In-Call User Alert (Voice Mute)
•
Multi Functional Button
The two options of priority for the Voice Announcement
available are:
• High – enables the voice of the feature to announce even
when the radio is receiving calls.
• Low – disables the voice of the feature from announcing
when the radio is receiving calls.
Procedure:
You hear a voice announcement when the features below are
preprogrammed in the radio.
• The radio powers up. The radio announces the current zone
and channel it is transmitting.
• Press the preprogrammed voice announcement button
(which specifically programmed to playback the current zone
and channel). The radio announces the current zone and
channel it is transmitting.
Note: Pressing this preprogrammed playback button will
always enable the voice feature to announce in High
priority.
All the three programmable buttons at the side of the
radio support this feature.