Toshiba Surveillix IKS-WP816R User Manual page 88

•
Flip – Track an object continuously when it passes under the camera by setting
Flip to Mechanical (M.E.) mode or Digital Flip (Image) mode.
•
M.E. Mode – M.E. is a standard mechanical operation. As the camera tilts to
the maximum angle, it will pan 180°, and then continue tilting to keep tracking
objects.
•
Image Mode – Image represents digital IMAGE FLIP, which enables the
camera to keep tracking objects seamlessly. With the Image mode, almost no
delay occurs in comparison to the M.E. mode.
Flip setting is manual-controlled only. If a Preset Position or a point for other
Note
function (ex. Tour) is set in the position that can only be reached through FLIP
motion, the Flip function must be enabled for the camera to move to that
position.
To make the Dome Camera tilt between a specific range, such as -10° or
Note
+190°, please go to the Tilt Range setting page to set the tilt angle range.
Otherwise, the Dome Camera will tilt 90° as the default setting.
The Privacy Mask function will be automatically disabled if the Image Flip
Note
function is enabled.
•
Speed by Zoom – Enable this function to have the pan and tilt speed (angle
distance) automatically scaled down when the camera is zoomed in. Enabling this
function will cause pan and tilt movements to be done in smaller increments the
further in the camera is zoomed, making movement while zoomed much easier.
•
ICR Function – The camera uses the IR cut filter to capture a clear image at night
time or in low light conditions. In the Auto mode, the internal circuit will automatically
decide when to remove the IR cut filter according to the image brightness level.
88