KitchenAid Instant Hot Hot Water Dispenser Installation And User Manual page 8

quick-
connect
fitting
collet
clamp
flexible
tubing
closed
open
8
Installation Instructions cont.
NOTE: Do NOT plug power supply cord into outlet.
8.
Connect 1/4" (6.4 mm) spout
tubing (longer tubing) to the rear
quick-connect fitting on top of tank.
Push tubing straight into fitting as far
as it will go. Pull on tubing. The
tubing should not come out when
properly installed.
Do Not lengthen, twist or tightly
bend tubing.
9.
Connect flexible tubing from
spout to center tank tubing using
clamp. Make sure flexible tubing
does not kink.
The flexible tubing may be shortened
if necessary.
10.
Install saddle valve following
kit instructions. If water supply line is
not copper, shut off water supply and
11.
Turn saddle valve handle
clockwise until lance pierces soft
copper tubing and valve is firmly
seated. If the water line is not copper,
turn the saddle valve handle
clockwise until the valve is firmly
seated. The valve is now in the
closed position.
12.
Slowly open saddle valve and
flush line into bucket to remove any
foreign material that may have been
trapped in the supply line during
saddle valve installation.
Close saddle valve.
NOTE: If you need to remove tubing,
push down on collet. Pull tubing out
of quick-connect fitting.
drain line. Drill a 1/4" (6.4 mm) hole
into water supply line for the saddle
valve piercing pin.
Place a bucket under open end of
water supply line. Turn on main water
supply valve to pressurize cold water
line. Check for leaks.