Hot Water Dispenser Use; Flush Hot Water Dispenser Tank Before Use; Set The Temperature; Dispense Hot Water - KitchenAid Instant-Hot KHWG260 Installation And User Instructions Manual

NOTES:
■ You may hear gurgling noises coming from the tank while the
water is heating. This is normal.
■
A small amount of hot water may flow from the faucet while
the water is heating. This is normal for the first time heating of
the dispenser.
■ The Temperature Control does not control the water delivery.
Push down and turn the faucet cap clockwise to control the
water delivery.
NOTE: Before using the hot water from the hot water dispenser
for the first time, allow the hot water dispenser to heat the water
for approximately 15 minutes.
1. Push down and turn the faucet cap clockwise to open the
faucet.
2. Allow the water to run for approximately 1 minute to flush hot
water dispenser tank.
The water temperature is thermostatically controlled using the
Temperature Control. The Temperature Control can be set to a
maximum temperature of 190ºF (88ºC) (approximate).
1. To raise the water temperature, turn the Temperature Control
clockwise.
2. To lower the water temperature, turn the Temperature Control
counterclockwise.
NOTE: The Max setting is recommended for best performance.
Turn the Temperature Control to a lower setting if vapor appears
near the faucet or if you hear the sound of water boiling.
1. Push down and turn the faucet cap clockwise to open the
faucet.
2. Release faucet cap after dispensing the desired amount of
hot water.
NOTES:
■ A short delay between the time the faucet cap is turned and
the hot water is dispensed is normal.
■
Water flow from the faucet varies, depending on how far the
faucet cap is turned.
8

HOT WATER DISPENSER USE

Flush Hot Water Dispenser Tank Before Use

Set the Temperature

Dispense Hot Water

■ The Temperature Control regulates the water heating
temperature. Rotate the Temperature Control clockwise to
raise the water temperature, or counterclockwise to lower the
water temperature.
■
Turn the Temperature Control to a lower setting if vapor is
appearing near the faucet or if you hear the sound of water
boiling.
3. Release the faucet cap and allow the water to reheat for
approximately 15 minutes before using.
4. Check that all installation steps are complete.
5. Check for leaks.
A. Faucet cap—Model series KHWG260
A