Packet Data Settings; Wireless Lan Settings - Nokia N78 User Manual

(EAP) plug-in, or
Complete the appropriate settings:
EAP plug-in settings
●
your service provider instructs.
Pre-shared key
●
password must be entered on the WLAN access
point device.
WPA2 only mode
●
are allowed to establish a connection in this mode.
Advanced WLAN settings
Select Options
>
following:
IPv4 settings
●
the subnet IP address, the default gateway, and the
IP addresses of the primary and secondary DNS
servers. Contact your internet service provider for
these addresses.
IPv6 settings
●
Ad-hoc channel
●
channel number (1-11) manually, select
defined.
Proxy server address
●
proxy server.
Proxy port number
●
number.
154
Pre-shared key to use a password.
— Enter the settings as
— Enter a password. The same
— Only WPA2 enabled devices
Advanced settings and from the
— Enter the IP address of your device,
— Define the type of DNS address.
(only for Ad-hoc) — To enter a
— Enter the address for the
— Enter the proxy port

Packet data settings

Press , and select
Connection
The packet data settings affect all access points using
a packet data connection.
Packet data connection
●
available
packet data, the device registers to the packet data
network. Starting an active packet data connection
(for example, to send and receive e-mail) is quicker.
If there is no packet data coverage, the device
periodically tries to establish a packet data
connection. If you select
uses a packet data connection only if you start an
application or action that needs it.
Access point
●
to use your device as a packet data modem to a
compatible computer.
High speed packet access
●
User
use of HSDPA (network service) in UMTS networks.

Wireless LAN settings

Press , and select
Connection
Show WLAN availability
●
displayed in the standby mode when a wireless LAN
is available.
Tools Settings
>
Packet data.
>
— If you select
and you are in a network that supports
When needed, the device
— The access point name is needed
— Enable or disable the
Tools Settings
>
Wireless LAN.
>
— Select whether
>
When
>
is