Page 1
LCD-Monitor Chassis : LS17MYA / LS17MYB LS19MYA / LS19MYB Model : 743N / 743B 743NX 943N / 943B SERVICE Manual TFT-LCD Monitor Contens 1. Precautions 2. Product specifications 3. Disassembly and Reassemble 4. Troubleshooting 5. Exploded View & Part List 6. Wiring Diagram 7. Schematic Diagram 743N / 743B / 943N / 943B Refer to the service manual in the GSPN (see the rear cover) for the more information.
1. Precautions 1. Precautions 1-1. Safety Precautions Follow these safety, servicing and ESD precautions to prevent damage and to protect against potential hazards such as electrical shock. 1-1-1. Warnings For continued safety, do not attempt to modify the circuit board. Disconnect the AC power and DC power jack before servicing.
1. Precautions 1-2. Servicing Precautions WARNING: An electrolytic capacitor installed with the wrong polarity might explode. Caution: Before servicing units covered by this service manual, read and follow the Safety Precautions section of this manual. Note: If unforeseen circumstances create conflict between the following servicing precautions and any of the safety precautions, always follow the safety precautions.
1. Precautions 1-4. Installation Precautions For safety reasons, more than two people are required for carrying the product. Keep the power cord away from any heat emitting devices, as a melted covering may cause fire or electric shock. Do not place the product in areas with poor ventilation such as a bookshelf or closet. The increased internal temperature may cause fire.
2. Product specifications 2-2. Spec Comparison to the Old Models Mckinley HAYDN Model (743N / 743B / 943N / 943B) (740B) Design Size 17” & 19” 17” Resolution 1280 x 1024 1280 x 1024 743N / 943N : Analog Input Analog / DVI 743B / 943B : Analog &...
2-3. Accessories Product Description Ccde. No Remark Quick Setup Guide BP68-00274B Warranty Card BH68-00633B (Not available in all locations) Samsung Electronics User’s Guide, Service center Monitor Driver, BN59-00585A Natural Color Pro Software D-Sub(15 Pin) Cable BN39-00244G 743N/943N Power Cord 3903-000042 743B/943B 2-4.
7. Schematic Diagram 7. Schematic Diagram 7-1. 743N/943N -Circuit Descriptions Location Function Remark Scaler Besides the ADC, LVDS, and scaling part, an MCU is embedded as well. All of 743N / 943N : IC200 them are integrated into one chip.
Page 40
7. Schematic Diagram 7-1-1. 743B/943B -Circuit Descriptions Location Function Remark Scaler Besides the ADC, LVDS, and scaling part, an MCU is embedded as well. All of 743B / 943B : IC200 them are integrated into one chip. SE756M-LF Flash Stores the MCU program embedded in the scaler. It is of a flash type and Memory MX25L1005 rewritable.
6. Wiring Diagram 6-2. Wiring Diagram - IP Board LVDS Connector (Connect to Panel) 3708-001150 EEPROM Flash memory 3701-001219 3701-001173 Function Connector (Connect to IP-Board) RGB Connector DVI Connector (PConnect to PC) (Connect to PC)
6. Wiring Diagram 6-3. Connector Functions Connector Functions CN102 DVI signal input termina (used on 743B / 943B only) * When a problem occurs : The No DVI output error may occur. CN1 ~ CN4 In Transmits the lamp current (6mA ~ 7mA) generated in the inverter to the lamp of the panel. * When a problem occurs: The Blank Screen error may occur.