Page 1
The DAP-1320 can be setup by two different methods: 1. Push button WPS (Wi-Fi Protected Setup) 2. Manual Note: In order to setup the DAP-1320 using WPS, you must have a WPS compatible router/access point Push Button WPS Step 1: Plug in the DAP-1320...
Page 2
How do I setup and install my DAP-1320? Step 3: Press and hold the WPS button on the DAP-1320 until it starts blinking green and then release. Once connected, the LED will be solid GREEN.
Page 3
How do I setup and install my DAP-1320? Step 4: Unplug and place the DAP-1320 approx half way between the router and the desired con- nection area. Note: To connect wireless to the DAP-1320, use the Wi-Fi Network Name (SSID) and Wi-Fi Pass- word information located on your configuration note.-á...
Page 4
How do I setup and install my DAP-1320? Step 2: From a wireless computer/device, scan for available networks and connect to the pre- defined SSID (Located on the Companion Card supplied with the DAP-1320 and on the bottom of the DAP-1320) example: Dlink-6DFC .
Page 5
You will be directed to the d-link setup page. Click next to start the setup. Step 4: Select the Manual configuration method and click “Next”. The DAP-1320 will scan for available wireless networks. Select the Wi-Fi network you would like the DAP-1320 to extend and click “Connect”...
Page 6
It is suggested to configure a name that is different from your "Primary" wireless network. Click Next Step 6: Confirm your wireless settings and click save Setup is now complete. Once the DAP-1320 has applied its settings, its light should be Green and you should be able to connect to the Extended Wi-Fi Network.