Drill The Holes In The Wall And Upper Cabinet - Kenmore 721.85062 Installation Instructions Manual

STEP 4 : PREPARE THE WALL AND UPPER CABINET FOR INSTALLATION
To avoid risk of personal injury, electrical shock or death:
• Note where electrical outlets and electrical wires are before you drill into the wall.
• Locate and disconnect power to any electrical circuits that could be affected by
installing this oven.
To avoid risk of personal injury, electrical shock or death, cover the edge of the power
supply cord hole with the power supply cord bushing.

Drill the Holes in the Wall and Upper cabinet

1. Drill holes on the circles. If there is a stud, drill a 3/16"
hole for lag screws. If there is no stud, drill a 3/4" hole
for toggle screws. Make sure to use at least 1 lag screw
in a stud, and 4 toggle screws in the drywall or the plaster.
2. Drill a 1/2" hole at points D, E and J on the upper
cabinet template.
NOTE: If the bottom of the upper cabinet is recessed
3/4" or more, you will need 2"x2" filler blocks
(not included) to provide additional support for
the bolts. See Figure 26.
• Mark the center of each filler block and drill a 1/2"
diameter hole at the mark.
• Align filler blocks over the two openings in the top of
the microwave oven cabinet and attach to cabinet
with masking tape. See Figure 27.
3. Cut or drill a 13/4 diameter hole at the area marked
"M", "Power supply cord hole" on the upper cabinet
template. If the upper cabinet is metal, you will need
to cover the edge of the hole with the power supply
cord bushing (supplied) to prevent damage to the
cord from the rough metal edge.
4. Cut out the venting areas (with the saber saw):
• Roof Venting: Cut out the shaded area marked
"L" on the upper cabinet template.
• Wall-Vented: Tape the rear wall template to the
rear wall, lining up with the holes previously drilled
for holes A and B in the plate. Cut out the shaded
area marked F on the REAR WALL TEMPLATE.
• Room-Vented: go to STEP 5, INSTALL THE MOUNTING
PLATE, located on page 14.
5. Complete whichever venting system you have chosen.
Use caulking compound to seal the exterior wall or
roof opening around the wall cap or roof cap.
WARNING
WARNING
Cabinet front Filler block
Cabinet
bottom shelf
Figure 26
Filler block
Figure 27
13