Sanyo SFX-32 Service Manual page 29

d) MODEM TEST
1) Press ~ + -]. (over 1sec.)
(Refer to Page 25)
II NIT IAL SET ? I
L
2) Press -1 3-times.
IMODEM TEST ? I
3) Press ~.
9600 BPS (0)
* Press WI to call for the next signal.
* Press ~q to call for the previous signal.
::.. .
SIGNAL ORDER:
...
9600 BPS(0) - 7200 BPS(0) + 4800BPS(0) - 2400BPS(0) - 300 BPS(0)
~ 21OOHZ + 11OOHZ - PB8 - NO SIGNAL - RETURN TO THE 1ST STAGE (9600BPS)
The signals of 9600, 7200, 4800, 2400 and 300BPS can be changed its carrier frequency pattern as shown
below.
Press e] to change its pattern at each stage.
(0) : 1850HZ continuously
(1) : 1650HZ continuously
(1:1) : 1650/ 1850HZ alternately (3.3ms/3.3ms)
(1:4) : 1650/ 1850HZ alternately (3.3ms/13.2ms)
1
time is a case of 300BPS
(4:1) : 1650/1850HZ alternately (13.2ms/3.3ms)
* Press ~].
+ MONITOR SPEAKER is activated.
* Press w] at NO SIGNAL stage. + Voice prompt can be heard. (Need to press (~]
before pressing -].)
4) Press = to finish.
e) HEAD TEST
1)
2)
3)
Press ~ + -]. (over 1sec.)
(Refer to Page 25)
INITIAL SET ?
Press m] 4-times.
HEAD TEST ?
Press ~.
INITIAL SET ?
1
A pattern of the head test starts to print on the recording paper. Press -c] * HEAD TEST ,
to interrupt printing.
After the print has been completed, the machine returns to STAND BY.
f) PANEL TEST
1) Press ~ +
mu].
(over 1sec.)
(Refer to Page 25)
2) Press ml 5-times.
3) Press ~.
The whole LCD and all LED will be turn over, and 2
times of the beeping tone will be heard.
4) Press Keys according to the contents of display. All keys
on the panel will be displayed in sequence.
5) Pressing -], SFX-32 returns to stand-by.
—27—
PANEL TEST ?
I
[L CD, LED, BUZZER]
4
[3]
1
I
I
[STOP]
I