Ice Cube Container; Drip Tray - Miele F 1471 Vi Operating And Installation Instructions

Cleaning and care
Aluminium frames
The frames on the shelves inside the
appliance and in the door are made
from aluminium.
Aluminium is affected by the way that
light falls on it, by the surrounding
environment and by the angle you
observe it from.
It is also susceptible to scratching.
The aluminium frames may suffer
discolouration or damage if soiling is
left on for too long. Remove any
soiling immediately.

Ice cube container

^ Pull the ice cube container out of the
appliance.
^ Empty it and rinse it with warm water.
^ Dry the container and spindle
thoroughly so that new ice cubes will
not freeze onto the surfaces.
To replace the ice cube container:
^ Push the container back into the
appliance until it clicks into position.
^ If you cannot push the container
back in all the way, turn the spindle
inside a little.
38

Drip tray

The drip tray catches excess water.
When the drip tray is full, the 0 symbol
in the ice/water dispenser control panel
will flash and dispensing will stop.
There are sensors in the drip tray which
measure when the drip tray needs to be
emptied.
To avoid a build-up of odour, the drip
tray should be cleaned every day.
When the 0 symbol flashes,
^ remove the drip tray cover and the
grille.
^ Mop out the drip tray using a sponge
or tea towel and then clean it.
^ Clean the drip tray cover and the
grille.
^ Replace the grille and the drip tray
cover.
The 0 symbol will now be highlighted in
white again.