Operation; Cleaning The Product; Other Information - Black & Decker PLATINUM DH2000SL Instruction Manual

INSTALLING AND REMOvING ThE BATTERY
WARNING:
removing or installing battery.
TO INSTALL BATTERY PACk: Insert battery pack into the
vac until an audible click is heard (Figure C). Make sure
battery pack is fully seated and fully latched into position.
TO REMOvE BATTERY PACk: Depress the battery release
button (6) as shown in Figure C and pull battery pack out of the vac.

OPERATION

FIGURE D
NOTE: ThIS PRODUCT IS FOR DRY PICk-UP ONLY.
• To switch the vac on, slide the on/off switch forward.
• To switch the vac off, slide the on/off switch back.
ASSEMBLY
FIGURE E
Remove the dust bowl by pressing the dust bowl release
•
button and pulling the bowl down and out.
• Remove the filter by pulling it out of the dust bowl.
• Install the filter into the dust bowl by aligning the filter
triangle with the dust bowl triangle and placing it firmly into
position as shown in figure F.
NOTE:
It is very important that the filter is correctly in
position before use.
• To install the dust bowl, place it back onto the front of the unit
and click firmly into position.
MOUNTING ACCESSORIES
• The brush tool (9) has a brush that can be used for
dusting and upholstery cleaning.
• The crevice tool (8) allows for vacuuming in narrow and
hard to-reach places.
• To attach an accessory, press the accessory into dust bowl.
• To remove an accessory, pull the accessory out of the dust bowl.

CLEANING ThE PRODUCT

WARNING:
without its filters.
NOTE:
The filter is re-usable, do not confuse them with disposable dust bags, and do not throw it
away when the product is emptied. We recommend that you replace the filter every 6-9 months.
IMPORTANT:
an empty dust bowl. If dust begins to fall back out of the product after it is switched off,
this indicates that the bowl is full and requires emptying.
• Remove the filter and shake or lightly brush any loose dust off the filter.
Empty the dust from the bowl and wash if necessary.
•
• Wash the filter regularly using warm, soapy water as shown in
figure G. Ensure that it is completely dry before using again.
NOTE:
The cleaner the filter is, the better the product will perform.
• The dust bowl can also be washed in warm soapy
water as shown in figure G. Ensure that it is dry before
re-attaching.
Never immerse the product in water. A damp cloth and
•
soapy water should be used to clean the exterior of the
motor section. Always ensure the product is completely dry before re-use or storing.
RUN TIME
• When fully charged, the average effective usage times are between 10-15 minutes.
• It may take several chargings before these times can be achieved.

OThER INFORMATION

If the product does not work, check the following:
• The charger was correctly plugged in for recharge. (It feels slightly warm to the touch.)
• The charger cord is not damaged and is correctly attached to the base.
• The charger is plugged into a working electrical outlet.
Make certain the vac is switched off before
Never use this cordless hand vacuum
Maximum dust collection will only be obtained with clean filters and
6
C
D
E
F
G