Vii. Test Page Print Mode; A. Generating The Test Page; Test Pattern - Canon CP660 Service Manual

VII. TEST PAGE PRINT MODE

The PS/PCL board has 5 types of test print patterns, each one enabling identification
of a fault in the image.
A. Generating the Test Page
1) While holding down the Menu and Enter keys, turn on the power.
2) Hold down the Menu and enter keys until the message "START SELF-TEST" appears
on the control panel of the printer.
3) Wait until the message "READY" appears as in the case of regular operation.
4) Press the Menu key several times to bring out the message "PRINT PAGES FROM
LIST"; then, press the Enter key.
5) Press the Up or Down arrow several times until the message "PRINT SERVICE
PAGE X" appears (X being 1 though 5, corresponding to the number of the chart
shown above); then, press the Enter key.
6) See that the test page is printed.
:
Caution
· If you have started the machine as you would normally, the above menu for service
test page would not be indicated.
· For displacement of registration, use the test page intended for the engine side
generated by pressing the DCON button. You may, however, use the test page
generated by selecting "PRINT SERVICE PAGE 5".
B.

Test Pattern

1 PRINT SERVICE PAGE 1
2 PRINT SERVICE PAGE 2
3 PRINT SERVICE PAGE 3
4 PRINT SERVICE PAGE 4
5 PRINT SERVICE PAGE 5
COPYRIGHT © 1999 CANON INC.
Download free service manual at http://printer1.blogspot.com
TYPE
Table 10-701
CANON 660/2100 REV.0 FEB. 1999 PRINTED IN JAPAN (IMPRIME AU JAPON)
CHAPTER 10 TROUBLESHOOTING
Remarks
Full-color 16 gradations (YMCK)
Gradation (YMCKRGB)
Full face halftone (Y, M, C, K)
YMCK vertical stripe
Controller Test Chart
10-93