ORDER NO.KM60210945S3 Printer KX-P1131 (for China) Subject : Service Manual Correction Please file and use this supplement manual together with the service manual for Model No.KX-P1131, Order No.KM69806596C8. This supplement applies to the KX-P1131 Chines Version. CONTENTS Page Page 1 Correction of Section “6.5 End of Paper Detector 4 Section “8.4.2 Pin Configuration...
KX-P1131 1 Correction of Section “6.5 End of Paper Detector” This section has been corrected as shown below: 6.5 End of Paper Detector The printer uses a mechanical switch for detecting paper out with continuous or single sheet paper. When paper is loaded in the printer, the lever is down, and the condition of the mechanical switch is on.
KX-P1131 3 Correction of Section “8.6.2 Main Board” The followings indicate the correction regarding the schematic diagram in the section 8.6.2 Main Board. <Correction 1> Correction F200 IC207 RA209 CN202 INAN INBN OUTA OUTAN IC201 OUTB GATE OUTBN CR MOTOR...
KX-P1131 4 Section “8.4.2 Pin Configuration” The following indicates the information regarding the pin configuration of CR motor driver IC207. This information has been omitted from the original service manual. 5 Correction of Section “8.5 Troubleshooting Flow Chart” The followings indicate the correction regarding the wave forms on pages 53 ~ 55 (original service manual).
KX-P1131 Replace the information regarding the wave form on page 54 with the following. Correction 7.2 ms 2V/div 3.6 ms 2ms/div IC201 70 - 73 Phase Signal Voltage Waveform Correction 7.2 ms 20V/div 3.6 ms 2ms/div QA200 3 , 5 , 7 , 9 Voltage Waveform (LF OR FF Switch ON) Replace the information regarding the wave form on page 55 with the following.