Advertisement
(Continued from the front page)
Step5 Setting Up FW-Client
Set up for operating the device and other target devices from
FW-Client.
2.
The following window
1.
Select [Start]→[Programs]
→ [Fujitsu Component
appears. To register the
Limited FW Client]. Or,
device, click [New
Appliance].
double-click the [Fujitsu
Component Limited FW
Client] icon.
3.
The following [New
4.
Choose the product type.
Appliance Wizard] dialog
Select [Other], and click
box appears. Click [Next].
[Next].
5.
Confirm the IP address
6.
Enter the IP address of the
setting. If you have set up an
device. Then click [Next].
IP address for the device at
Step 3, Select [Yes, the
Appliance has an IP
address], and click [Next].
<Inquiry about our products>
FUJITSU COMPONENT LIMITED Marketing Group
TEL: 81-3-5449-7006
E-mail: promothq@fcl.fujitsu.com
URL: http://www.fcl.fujitsu.com/en/
7.
The contents of the dialog
8.
The contents of the dialog
box are shown as below.
box are shown as below,
Search for the device from
and the registration of the
device is completed.
the network.
9.
The device is added to the
appliance list as shown
below.
Step6 Running an Update
Check the current connection status of a server module by
re-synchronizing FW-Client and the device.
1.
Click the device registered in
2.
The [Resync Appliance
the appliance list, and click
Wizard] dialog box appears.
[Resync] shown at the
Click [Next].
bottom.
3.
On the following dialog box,
4.
The contents of the dialog
select the required check
box are shown as below,
box(es), and click [Next].
and data is retrieved from
the device.
5.
The updated information is
6.
The contents of the dialog
shown. The dialog box
box are shown as below,
below shows that a new
and the update is completed.
server module has been
detected. Click [Next].
Step7 Access a Target Device
Perform an operation on a connected target device.
You need to install the version after 1.6 of JAVA Runtime
Environment (JRE) in the remote client PC to operate the target
device. Since JRE is stored in attached CD-ROM, please use it.
1.
Click the [Servers] tab on the
2.
The following login dialog
FW-Client window, select
box appears. Enter the
and double-click the server
Username and password.
module detected and
By default, "admin" is
registered at Step6.
registered both for the
Username and the
Password. After entering,
click [OK].
3.
The following [Video Session Viewer] window appears, and
target device operations are enabled.
To finish, click [X] on the top right of the Video Session Viewer
window.
NOTES
Adjusting the mouse pointer speed on the server
When a remote user accesses a target server to perform an
operation, the mouse cursors on the remote user side and target
server side may not coincide. When this happens, adjust the
mouse pointer setting for the operating system on the target
server so that the two mouse cursors coincide.
Setup for Windows XP, Server 2003, Vista
-Click [Control Panel] → [Mouse] to show [Mouse Properties].
-Click the [Pointer Options] tab.
-In the [Select a pointer speed] section, move the slider to the
middle. Clear the [Enhance pointer precision] check box.
-In the [Snap To] section, clear the [Automatically move pointer
to the default button in a dialog box] check box.
-Click the [OK] button to finish.
For software setup or details on operations, refer to
the Installer/User Guide in the CD-ROM provided
with the device.
NC14013-0922RS-02
Advertisement
