Replacing The Power-Status Light Board; Procedure; Post-Requisites - Dell Inspiron 20 Service Manual

Replacing the Power-Status
Light Board
WARNING: Before working inside your computer, read the safety
information that shipped with your computer and follow the steps in
Before Working Inside Your
computer, follow the instructions in
Computer. For more safety best practices, see the Regulatory
Compliance home page at dell.com/regulatory_compliance.

Procedure

1 Slide the power status-light board into the alignment post on the display
bezel.
2 Align the screw holes on the power status-light board with the screw
holes on the display bezel.
3 Replace the screws that secure the power status-light board to the
display bezel.
4 Slide the power-status light cable into the power-status light board
connector and press down on the connector latch to secure the cable.

Post-requisites

Follow the instructions from step 3 to step 5 in "Replacing the
Computer. After working inside your
After Working Inside Your
Back Cover".
33