Table of Contents
Advertisement
the guide
cutter 1,
2
1,
guide cutter 3
d)
Remove the CIS assembly.
(See figure 6-11)
* CIS should
be replaced
with CIS assembly.
cl
(2) Reciacement of the Thermal Head
.,
a)
b)
c)
d)
'11
Gather the original guide to the center and remove
two screws securing the receiving cover.
Press the Open button and remove two screws
securing the cover located under the thermal head.
(See figure 6-1 2)
Disconnect the connector of the thermal head.
Remove two screws securing the thermal head.
lfT—————
–--—~
—
two screws securing the guide cutter
3
connector
of the guide cutter
J
FIGURE 6-15
(4) Replacement
of the ADF (Automatic
Document
Feeder)
unit.
a)
Open the operation panel.
b) Remove two screws securing the ADF unit. (See
figure 6-16)
two screws securing
lk%4EADFuni'
FIGURE 6-12
~
ADF unit
FIGURE 6-16
two screws securing the thermal head
c) Replace new ADF unit and check the performance.
bracket
bracket f) pressthisdirection
$
FIGURE 6-13
When attaching the thermal head to the bracket
head, the thermal head should be pressed the
arrow direction. (See figure 6-13)
(3) Replacement of the Auto Cutter
a) Remove the receiving mechanical unit. (Refer to
the 6-1 -(3))
b) Remove one screw securing the cutter unit (See
figure 6-14)
receiving mechanical
unit
one screw secu
the guide cutter
utter unit
6-14
c) Disconnect the connector of the cutter unit.
d) Remove three screws securing the black guide
cutter (three pieces) from the cutter unit. (See figure
6-15)
Please note that two wire fixers are fixed together
with screws.
When re-assembling,
put them to the same
position.
—24—
Advertisement
Table of Contents
