Sony AWS-750 Operating Instructions Manual page 32

For details on configuration, see "[Input Channel
Assign]" (page 99).
Viewing the audio level meter
Over-level indicator
Lights red at the 0 dB
level.
The bottom "–∞" level
is always lit green.
2
Drag the slider for the PGM OUT fader to adjust the
program output level.
Checking each audio input
You can check the audio of each channel via the
HEADPHONES jack or the internal speakers using the
respective [PFL] buttons (pre-fader listen).
Tap and hold a [PFL] button to monitor only the audio
from that channel while the button is held. The audio will
be monitored until you release the button.
Tip
The program output, AUX output, and MIX output are
not affected during pre-fader listen.
[PFL] buttons
32
Step 5: Audio Mixing
Lights green up to
the current level.
PGM OUT fader
In addition, the audio level meter switches to PFL mode
(the button display switches to [PFL]) while the [PFL]
button is held down, allowing you to check the levels of
the audio input.
Adjusting the audio level for monitoring
Drag the [Monitor Level] slider to adjust the output level
of the HEADPHONES jack and internal speakers within
a range of 0 to 255.
[Monitor Level] adjustment
For details on further operations and adjustments, see
"Performing Detailed Audio Adjustments" (page 73).
Afterward
Proceed to "Basic Operations" (page 33) to gain a better
understanding of this unit's functions and how to master
their operation.