Advertisement
1
NOTES ON ASSEMBLY OF EACH PART
[Attachment of the Head Cushion]
Double-back tape is attached to the
A
When replacing the double-back tape, clean the surface of the
be attached.
[Component Formation of the Hanger Section]
The
(No.5) and (No.6) and the
Hanger
broken-line ellipses shown below.
If detaching is difficult, replace the whole the
B
[Attachment of the Housing Shaft]
Insert the housing shaft with the flat surface at the end facing upward, as shown in the figure below.
C
D
[Attachment of the Housing Shaft and Spring]
When assembling the
(illust) Be careful of their relative positions.
E
F
4
1
2
(No.22).
Head Cushion
Hanger Cover
Headband Assy
(No.34) and
Housing Shaft
Spring
OK
Housing Shaft
2
3
(No.7) to which new double-back tape is to
Headband
(No.17) are adhered at the locations indicated with the red
(No.4).
( No.36), be careful of their relative positions.
Spring
HDJ-1500-K
3
NG
Spring
Housing Shaft
4
4
Advertisement
