Table of Contents
Advertisement
XL-1500W
Setting the clock
This may be operated only with the remote control.
In this example, the clock is set for the 24-hour (0:00) display.
1
Press the CLOCK button and within 3 seconds, press
the MEMORY button.
2
Within 1 minute, press the PRESET (
select 24-hour or 12-hour display and then press the
MEMORY button.
"0:00"
The 24-hour display will appear.
(0: 00 - 23:59)
"AM 12:00"
The 12-hour display will appear.
(AM 12:00 - PM 11:59)
Note that this can only be set when the unit is first installed or it
has been reset.
Remote control
Battery installation
1
Remove the battery cover.
2
Insert the supplied batteries according to the direction indi-
cated in the battery compartment.
When inserting or removing the batteries, push them towards the
battery terminals.
3 Replace the cover.
Precautions for battery use:
Replace all old batteries with new ones at the same time.
Do not mix old and new batteries.
Remove the batteries if the unit is not to be used for long periods
of time. This will prevent potential damage due to battery leak-
age.
Caution:
Do not use rechargeable batteries (nickel-cadmium battery, etc.).
Installing the batteries incorrectly may cause the unit to malfunc-
tion.
Notes concerning use:
Replace the batteries if the operating distance is reduced or if the
operation becomes erratic. Purchase 2 "AAA" size batteries (UM-
4, R03, HP-16 or similar).
Periodically clean the transmitter on the remote control and the
sensor on the unit with a soft cloth.
Exposing the sensor on the unit to strong light may interfere with
operation. Change the lighting or the direction of the unit.
Keep the remote control away from moisture, heat, shock, and
vibrations.
OPERATION MANUAL
3
Within 1 minute, press the PRESET (
adjust the hour and then press the MEMORY button.
When the 12-hour display is selected, "AM" will change automatical-
ly to "PM".
4
Within 1 minute, press the PRESET (
adjust the minutes and then press the MEMORY button.
The hour will not advance even if minutes advance from "59" to
"00".
The clock starts from "0" second. (Seconds are not displayed.)
To confirm the time display when the power is on:
Press the CLOCK button.
or
) button to
The time display will appear for about 5 seconds.
Note:
The "0:00" or time will flash at the push of the CLOCK button when the
AC power supply is restored after a power failure or unplugging the unit.
Readjust the clock as follows.
To readjust the clock:
Perform "Setting the clock" from the beginning. If the time display is
flashing, step 2 (for selecting the 24-hour or 12-hour display) will be
skipped.
To change the 24-hour or 12-hour display:
1
Clear all the programmed contents.
2
Perform "Setting the clock" from the beginning.
Test of the remote control
Face the remote control directly to the remote sensor on the unit.
The remote control can be used within the range shown below:
Press the ON/STAND-BY button. Does the power turn on? Now, you
can enjoy the music.
Remote sensor
0.2 m - 6 m
(8" - 20')
– 6 –
or
) button to
or
) button to
Advertisement
Table of Contents
