Toshiba TRST-A10 SERIES Quick Installation Manual

TOSHIBA REMOTE RECEIPT PRINTER
TRST-A10 SERIES
Quick Installation Manual
This sheet contains only the quick Installation procedures. Please be
sure to read the Owner's Manual in the web site for further
information about this printer.
Important Information to the User
In order to meet Product Safety, FCC and CE marking requirements, it is advised
to use the power supply, power cord, and interface cable which were shipped with
this product. Otherwise these devices need to meet following standards.
Power Supply
The power supply should follow UL/EN/IEC60950-1 certification, Class I power
supply with SELV (Secondary Extra Low Voltage), non-energy hazard output,
limited power source, input rated 100-240 Vac, 1.5/0.8 A, 50/60 Hz, output rated
24 Vdc, 3.15A.If this product is used with a power supply different from the
Toshiba TEC power supply, you will need to test this power supply and the
Toshiba TEC printer to comply to FCC and CE mark certification.
Interface Cable
You are advised to use a shielded (360 degree) interface cable with this product.
The shield must be connected to the frame or earth ground connection or earth
ground reference at BOTH ends of the cable.
If another cable is used than described above you will need to test this cable with
the Toshiba TEC printer and your system for FCC and CE mark certification.
Power Cord
For this product a UL listed, detachable power cord is required. When the power
supply is mounted on the floor, a power cord with Type SJT marking is required.
Outside the US, power cords need to meet the particular country's certification and
application requirements. If a power cord is used different from described above
you might violate safety certifications which are in force in the country of use. The
socket-outlet needs to be installed near the equipment and must be easily
accessible.
1