Advertisement
LASER BEAM SAFETY PRECAUTION
Pickup that emits a laser beam is used on thk CD section.
00
.4
CAUTION :
USE OF CONTROLS
OR ADJUSTMENTS
OR
PERFORMANCE
OF PROCEDURES
OTHER
THAN THOSE SPECIFIED
HEREIN MAY RESULT
IN HAZARDOUS
RADIATION
EXPOSURE.
LASER OUTPUT ................ 0.6 mW Max. (CW)
WAVE LENGTH .................790
nm
o
0
1=
-
—."-.
[Eia
r""'--
A?
.
w
.
,,
J
k
If
"2
I
—,——.
.
!'
——JJl..8——
DISASSEMBLY
AND ASSEMBLY
Unplug the AC power cord and remove the batteries
before disassembling
the unit. Remove cassettes
or CDs from the unit.
If bundles of wire are undone during the disassembly
process, be sure to return them to their original
state after operations
are
complete. Make sure that you have the necessary
fixers (614 1294971 ) for bundling
wires on hand beforehand.
Make sure that lead
wires are not too close to heat producing
parts such as heat sinks.
1. CABINET
(1)
Remove the battery lid.
(2) Remove the 6 rear cabinet mounting screws.(
@)
(3) Remove the VOLUME and DYNAMIC
BASS control knob.(
A)
(4) Press the STOP/EJECT
button.
(5) Open the cassette compartment
Iid.(
B)
2.
CD TOP LID BLOCK
(D+
PUSH
---@
Befor attaching
the cabinet, secure the buttons of the tape deck
in place using adhesive
tape.
3.
CHUCKING
PULLEY
m
\
Mount the spring
wire, attaching
parts (A}. (B), and (C) in
sequence.
-1-
To remove the chuck pulley, push in the direction indicated by
the arraws ( @)
and pull
out (
A)
(to prevent hook from breaking
off .)
Advertisement
