Setting Lists Of The Remote Menu - Sony BVM-D9H1j Operation Manual

D Assigning the Remote Control Functions — REMOTE Menu

Setting Lists of the REMOTE Menu

This section explains the setting lists displayed in the
menu.
How to read the setting lists
• For purposes of explanation, each setting list is
preceded by a menu number. These numbers are not
displayed on the screen.
For more information about the menu number, see "About
menu numbers" on page 26(E).
• The arrow mark (÷) refers you to another setting list
that appears after you make the setting, or to an
operation that is carried out as a result of the setting.
When there is no arrow mark, the menu does not have
any sub-list.
[D] REMOTE menu
Select the type of remote control.
SERIAL REMOTE : Set the address and group
number of the monitor controlled via the SERIAL
REMOTE connector. ÷[D1]
PARALLEL REMOTE: Select whether parallel
remote control will be used or not (ON or OFF.)
PARALLEL REMOTE CONFIG : Set the pin
assignments for the PARALLEL REMOTE
connector. ÷[D2]
[D1] SERIAL REMOTE menu
Set the monitor address and group number.
MONITOR ADDRESS: Enter a number.
GROUP ADDRESS: Enter a number.
[D2] PARALLEL REMOTE CONFIG menu
Select the PARALLEL REMOTE connector pins for
which you want to change the function. The factory
settings for each pin are given below. ÷[D211]
PINs 1 to 4, and PIN 6 of the PARALLEL REMOTE
1 and 2 are common settings.
1 PIN: CH01
2 PIN: CH02
3 PIN: TALLY RED
4 PIN: TALLY GREEN
5 PIN: EXT SYNC (PARALLEL REMOTE [1])
GND (PARALLEL REMOTE [2])
6 PIN: UNDERSCAN
7 PIN: 16:9
8 PIN: 4:3 MARKER
38
(E)
Note
PINs 1 to 4, and PIN 6 of the PARALLEL REMOTE
1 and 2 are connected inside the unit, therefore
different functions cannot be assigned to those pins.
[D211] (1/2) 1-8 PIN menu (1/2)
Assign a function to the selected pin.
CH: Select a channel number. Enter the desired
channel number with the numeric keypad.
----: Set to unused.
UNDER SCAN: Set underscan on or off.
16:9: Set a 16:9 aspect ratio on or off.
H DELAY: Set the horizontal sync display on or off.
V DELAY: Set the vertical sync display on or off.
EXT SYNC: Set the synchronization to external sync
signals enabled or disabled.
APERTURE: Set the correction of frequency
characteristics enabled or disabled.
MONO: Set monochrome display on or off.
BLUE ONLY: Set the blue signal pictures display
(monochrome) on or off.
[D211] (2/2) 1-8 PIN menu (2/2)
Assign a function to the selected pin.
R OFF: Set cutting red beams enabled or disabled.
G OFF: Set cutting green beams enabled or disabled.
B OFF: Set cutting blue beams enabled or disabled.
4:3 MARKER: Set the 4:3 marker display on or off.
CAPTION VISION: Set Caption Vision on or off.
TALLY RED: Set tally red on or off.
TALLY GREEN: Set tally green on or off.
DEGAUSS: Set degaussing on or off.
POWER OFF: Set the monitor power on or off.
For the pin assignment, see "PARALLEL REMOTE 1/2
connectors" in the Location and Function of Parts on page
13(E) for BVM-D9H1U/D9H1E/D9H1A/D9H5U/D9H5E/
D9H5A or page 22(E) for BVM-D14H1U/D14H1E/
D14H1A/D14H5U/D14H5E/D14H5A.