Completing The Fru Replacement - Lenovo ThinkCentre 7515 Hardware Maintenance Manual

4. Note the front audio and USB assembly cables routing and remove the screw
Figure 37. Removing the front audio and USB assembly
5. Remove the front audio and USB assembly.
6. Route the cables for the new front audio and USB assembly through the hole in
7. Install the new front audio and USB assembly into the chassis and secure it
8. Connect the new front audio and USB assembly cables to the system board. See
9. Reinstall the front bezel.

Completing the FRU replacement

After replacing the FRUs, you need to reinstall any removed parts, reconnect and
route any internal cables, reinstall the computer cover, and reconnect any external
cables, including telephone lines and power cords. Depending on the FRUs
replaced, you might need to confirm the updated information in the Setup Utility
program, see Chapter 6, "Using the Setup Utility program," on page 51.
Note: When the power cord is first plugged in, the computer might appear to turn
To reinstall the computer cover and reconnect cables to your computer:
120
Hardware Maintenance Manual
that secures the front audio and USB assembly to the chassis.
the chassis to the system board.
with the screw.
"Locating parts on the system board" on page 89.
What to do next:
v To work with another piece of hardware, go to the appropriate section.
v To complete the replacement, go to "Completing the FRU replacement."
on for a few seconds and then turn off. This is a normal sequence to enable
the computer to initialize.