Removing Or Installing The Heat Sink And Fan Assembly - Lenovo ThinkServer TD230 Hardware Maintenance Manual

Figure 62. Mini SAS cable with four SAS connectors
Note: When you are connecting the cables to the corresponding SAS connectors (0-3) on the hot-swap hard
disk drive backplanes, follow the sequence indicated by the number on the label on each cable.
SAS connector
6
7
8
9

Removing or installing the heat sink and fan assembly

This section provides instructions on how to remove or install the heat sink and fan assembly.
Removing the heat sink and fan assembly
Attention:
Do not open your server or attempt any repair before reading and understanding the Safety Information and the
Warranty and Support Information on the ThinkServer Documentation DVD that came with your product, and
"Guidelines" on page 39. To obtain a copy of the publications, go to:
http://www.lenovo.com/support
This section provides instructions on how to remove the heat sink and fan assembly.
CAUTION:
Hazardous moving parts. Keep fingers and other body parts away.
CAUTION:
The heat sink and fan assembly might be very hot. Turn off the server and wait three to five
minutes to let the server cool before removing the server cover.
96
ThinkServer TD230 Hardware Maintenance Manual
SAS cable label
P1
P2
P3
P4
SATA/SAS connector on the
hot-swap hard disk drive
backplanes
SATA/SAS connector 0
SATA/SAS connector 1
SATA/SAS connector 2
SATA/SAS connector 3