Status Selection; Sending A Selective Call; Communication Procedures; Call Termination - Motorola GM950 User Manual

S

Status Selection

If Function button (6) or one of the programmable
option buttons has been configured for Status
Selection, the status number may be changed and
a call set up in a similar way to that described
above for Address Selection. The edit status
display looks like this:
1 2 3 4 5 6 7
S

Sending a Selective Call

When you have selected channel, address or status
as required you are ready to transmit. You should
only make a call when the channel is free (red
indicator (4) does not flash). If in doubt, press the
monitor button (5) to listen to the channel.
Depending on configuration of your radio, press
Base Call button (13a), or Variable Call button
(13b), or PTT (14) or
The red indicator lights.
After sending out your call please wait until the
conversation is set up.
S
button, to set up the call.
Status Selection/Sending a Call/Communication Procedures

Communication Procedures

Communication Procedures
Take the microphone out of its holder. Press the
transmit (PTT) key (14) on the side of the
microphone while talking, release it while listening.
Speak in a normal tone of voice, keeping a distance
of 5-10 cm from the microphone. When transmitting
the red indicator (4) will light continuously. Your
radio may be configured for 'Transmit Inhibit' under
certain conditions (e.g. when the channel is in use
by other users) in which case, the channel busy
tone will sound when you press the PTT key to
indicate that transmission is inhibited.
If your radio is equipped with a transmit time out
timer (TOT), a warning tone will sound a few
seconds before the transmission is cut off. The
radio may be programmed to inhibit retransmission
within a preset time.

Call Termination

Hang up the microphone in its holder when your
conversation has ended.
5
English