Table of Contents
Advertisement
Operating Instructions
®
Busch-Wächter
Pos: 26 /#Neustruktur#/Online-Dokumentation (+KNX)/Überschriften (--> Für alle Dokumente <--)/1. Ebene/G - L/Inbetriebnahme @ 11\mod_1279185496977_15.docx @ 83035 @ 22221122222 @ 1
7
Commissioning
Pos: 27 /#Neustruktur#/Online-Dokumentation (+KNX)/Inbetriebnahme/Waechter/Inbetriebnahme - 6841 IR-Handsender @ 28\mod_1347354324124_15.docx @ 232666 @ 1111111122 @ 1
7.1
Removing the protective foil
Fig. 2:
Protective foil on the battery
1. Remove the protective foil from the battery before commissioning.
7.2
Programming the device
Fig. 3:
Remote control
2. Press the "AUTO" button on the remote control for at least 3 seconds within the period of 10 minutes after
activating the power on the Busch-Watchdog.
-
The Busch-Watchdog must be de-energized for at least 30 seconds.
-
The remote control will then automatically connect itself to the Busch-Watchdog, and the Busch-
Watchdog will flash if the reception is correct.
-
Repeat these steps to program a maximum of 9 additional remote controls.
Pos: 28 /#Neustruktur#/Online-Dokumentation (+KNX)/Überschriften (--> Für alle Dokumente <--)/1. Ebene/U - Z/Wartung @ 21\mod_1328188606500_15.docx @ 138248 @ 111111 @ 1
8
Maintenance
Pos: 29 /#Neustruktur#/Online-Dokumentation (+KNX)/Wartung/Waechter/Wartung - 6841 - IR-Handsender @ 28\mod_1347354354592_15.docx @ 232680 @ 111 @ 1
8.1
Battery change of remote control
+
CR 2025
Fig. 4:
Changing the battery
1. Pull the battery holder out of the remote control.
2. Insert a new battery of type 2025. The plus pole of the battery (+) must be on top.
3. Push the battery holder back into the device.
=== Ende der Liste für Textmarke Content ===
Operating Instructions | 1473-1-8140
Commissioning
— 9 —
Advertisement
Table of Contents
