Call Waiting; Call Reject; Multipoint; Ear Loop Attachment And Removal - LG HBM-520 User Manual

How to use

Call waiting*

- Answer a second call without hanging up the first call by pressing the
CALL button for 1 second. Press the CALL button for 1 second to
return to the original call.
- Briefly press the CALL button to terminate the active call or both calls
at once. (subject to handset's support)

Call Reject*

- Activate Call Reject by pressing the CALL button for 1 second when
the handset rings.
* It is possible to use these functions only when your handset supports
them. For further information about using these features, please
consult your handset's user manual.

Multipoint

The LG HBM-520 is capable of having two handsets connected to the
Headset at the same time. This will give you the freedom of having only
one Headset to operate both your handsets.
Multipoint Connect
- Pair the Headset with one of your Bluetooth-enabled handsets.
(per the pairing instructions on pages 5-6).
- Turn off the Headset.
- With the power off, press and hold the PWR button on the HBM-520
for 5 seconds to enter Manual Pairing mode.
- Now, pair and connect the Headset with your other Bluetooth-enabled
handset. (This will be your Primary handset).
- Once this handset is paired and connected, go back and connect the
first paired handset to Headset. (This will be your Secondary handset).
* Note: When the HBM-520 is connected to two handsets at the same
time (Multipoint), the Headset calling functions will work with
the most recently used handset.
Calling Function
- Voice Dial and Last Number Redial features work with the Primary
handset. (most recently used handset).
- The first connected device is set as primary handset and the next
connected device is set as secondary handset.
- The device which made the last outgoing call will always be set as
the primary handset.
- To answer an incoming call on your secondary handset, while on a call
on your primary handset, hang-up the active-call (briefly press the CALL
button) and then answer the incoming-call (briefly press the CALL
button again).
8

Ear Loop Attachment and Removal

Attaching the ear loop
- Hold the ear loop just above the base (C shaped part), and snap it
into place behind the speaker on the HBM-520.
Removing the ear loop
- Hold the ear loop at the base (C shaped part), and pull, to unhook
the ear loop from the HBM-520.
Note : The ear loop can be attached to the HBM-520, as an option,
if necessary. Not every user will need to attach the ear loop.

Summary of button functions

HBM-520
Function
Status
Power on Power off
Power off Power on
Volume up Talking
Volume down Talking
Transferring a call Talking
Answering a call Ringing
Ending a call Talking
Call waiting Talking
Last number redial Idle
Voice dialing Idle
(handset must support)
Manual pairing Power off
Call reject Ringing
How to use
Action
Press the PWR button for 3 seconds.
Press the PWR button for at least
4 seconds.
Briefly press the Volume Up button.
Briefly press the Volume Down button.
- Handset to Headset
Briefly press the CALL button on the
HBM-520(Headset and handset must
be paired)
- Headset to handset
Press and hold the VOLUME UP button
on the HBM-520 for 5 seconds.
Briefly press the CALL button.
Briefly press the CALL button.
Press the CALL button for 1 second.
Press the CALL button for 1 second.
Briefly press the CALL button.
Press the PWR button for 5 seconds.
Press the CALL button for 1 second.
9